Leitner Designs bed rack

[steffen707]

Hard to see, but looks like my suspicions were correct. Does this bar interfere with PLYWOOD hauling?

Sponsored

 

[Jake]

Hey @steffen707 I added some light to the picture and it kinda looks like no problem. Suggest you ask the Leitner folks to confirm the distance between the bars. And FYI I doubt you would be able to have any kind of tonneau cover on when you have this rack on your truck.

 

[steffen707]

Hey @steffen707 I added some light to the picture and it kinda looks like no problem. Suggest you ask the Leitner folks to confirm the distance between the bars. And FYI I doubt you would be able to have any kind of tonneau cover on when you have this rack on your truck.

hey @Mjolnir can you measure from bottom of the bed to the bottom of the angled bar support attached "A"?

Can you also measure distance between the end of the metal mounts "B"? should be right around 47-49"

 

[JeepDreams]

Doesn't look plywood rated from my perspective...

 

[steffen707]

Doesn't look plywood rated from my perspective...

me either, needs some modification for plywood rated....rating

 

[attworth]

@steffen707 the measurements are on leitners website. It is NOT wide enough for a full sheet. They do sell clamp things you can put on the cross bars to haul lumber on top of the rack.

 

[steffen707]

@steffen707 the measurements are on leitners website. It is NOT wide enough for a full sheet. They do sell clamp things you can put on the cross bars to haul lumber on top of the rack.

ahh, they show 44.9" between bars. not sure what the height from bed to bracket is though.

 

[Mjolnir]

hey @Mjolnir can you measure from bottom of the bed to the bottom of the angled bar support attached "A"?

Can you also measure distance between the end of the metal mounts "B"? should be right around 47-49"

Sure thing. Once it stops raining I can do that for ya

Sponsored