MaximusDecimusMeridius
Well-Known Member
Looks good!That's what I thought but I pulled it up on my phone and another pc. Let me edit it and reload the pic. Try it again
Sponsored
Looks good!That's what I thought but I pulled it up on my phone and another pc. Let me edit it and reload the pic. Try it again
Ultimately had the dealership install it prior to purchase but it is a Warn Elite Full Width bumper. The dealership price matched the cheapest price I could find online. Labor was $52,000. I talked them down from $59,000Nice upgrades. Where did you get the bumper from?
Two reasons I like the Warn bumper: 1. it allows the winch to sit low in the bumper and not block as much air to the engine and 2. It allows you to use your stock fog lamps.That is the perfect bumper and winch setup
That's a lot of money to install a Bumper. Did it take them 5,000 hours to install.Labor was $52,000. I talked them down from $59,000
1,512 hoursThat's a lot of money to install a Bumper. Did it take them 5,000 hours to install.
Did you buy the 5”1” or the 5’2” version? I believe the new Colorados have the 5’2” bed. Thanks for the helpInstalled the Maxmate tonneau cover (for Colorado, picked up at Amazon.) Looks great and very happy with the look, function, and price. Only thing I did a bit different on the install that I haven't seen anyone else do is adding some padding under the rail corners closest to the tailgate. The rails from the kit are padded underneath, but the last half inch or so isn't and I didn't want it digging into the top of the truck rail. Which is also plastic. I just used some of the extra padding that came with it.
5'2" for the model year 2015-2018.Did you buy the 5”1” or the 5’2” version? I believe the new Colorados have the 5’2” bed. Thanks for the help
+1 Dittoyou seem like you are on the wrong forum. ¯\_(ツ)_/¯
Actually the alignment wasn't the issue, it was just holding the mounting plate still. I didn't have a clamp or even any tape handy (and couldn't get my second hand in there), so every time I touched the pedal bracket to the screws the whole mounting plate would slide backwards. Very frustrating. My wife, being only 5'2", could get both arms in there at the same time...though it was almost too small a space for her to fit, either.What was the secret to get the holes in the plate aligned with the screws?
It’s a tough one to install....
Whats wrong with the old winch plate?New winch, new winch plate:
Old
New
Moral of this story, buy a quality winch plate. This new one is the Warn.
The old one is this JCR