AstroZombie
Well-Known Member
- Thread starter
- #1
This past weekend I got and installed Nilight LED lights and SEVEN X hood light mounts. This all cost me less than $60 and took less than an hour to install. I used Kuject solder seal connectors, some shrink tubing, and fabric electrical tape to match the factory stuff..
The solder joint are really nice. You just use a heat gun. The ends fuse to wire sheath to create a watertight seal then the metal inside melts to solder the wires together. Then i just covered them up with shrink tubing to his the joint.
I used a wire fish rod to pull the driver side light wires through the channel.
All in all a very easy project if you have the factory aux block. here is the before and after.
The solder joint are really nice. You just use a heat gun. The ends fuse to wire sheath to create a watertight seal then the metal inside melts to solder the wires together. Then i just covered them up with shrink tubing to his the joint.
I used a wire fish rod to pull the driver side light wires through the channel.
All in all a very easy project if you have the factory aux block. here is the before and after.
Sponsored