Search results

$33,000 2020 Jeep Gladiator Rubicon 48k miles, garage kept, one owner Gladiator Rubicon. All service done locally at jeep dealer. Bed liner, tri-fold tonneau cover, long range car starter, upgraded all speakers + kicker hideaway 10 inch sub. New (1k miles) 35 Falken Wildpeak A/T 4s. LED...

No problem, good deal!! Enjoy the soft top. Total game changer in my opinion.

I took all 4 bolts out and then had my wife pull back on the top, while folded back, and then retightened everything. Problem solved. I noticed that the drivers side wasn't fully "seated" into the channels. That may be your issue too.

was hoping to just buy the door. Will see how much it bothers me before I buy a whole new hub. thanks,

So, I hacked up the media door in my gladiator this evening. Anyone know if there is a part number for just the door bezel. The piece that snap onto the whole hub. thanks,

Status update for anyone who cares :). The HS10 is legit. it is perfect for this application in my opinion. Saves space and adds just enough, too much if you crank it. Was talking with the stereo shop guy about the 4-channel amp and he bascially said, “well with the amp we can adjust the...

Ahh what the hell. I’m keeping the appointment and the local stereo shop. Might as well get this done right.

That is very likely. There's no way it should sound as crappy as it does. So, I'm guesssing I'll have to cut the harnesses and switch them? thank you!

my wallet disagrees :).

With the difference in sensitivity ratings between the two sets. My infinitis should be better (louder at least) than the MB's, correct? I'm honestly asking, because I have no idea. Thanks,

Biting the bullet and having a local shop install the HS10 and a 4 channel amp. Was driving around today and the current setup is just so damn bad.

I’ll probably have to. How’s was the install? I’m guessing it’d be best to do any kind of 4-channel amp the same time as the HS10.

No amp. Will probably have to install one at some point. Will see what happens after HS10 and bass blockers up front are installed. Hoping it will be good enough after that. The 6x9”s do look good though :). Had some help from my oldest on the install, that was fun and brought back a lot of...

So, recently finished up an install of Infiniti Primus 693M's with MB Quart adapters in my soundbar along with Infiniti REF 307F's in the dash. These 6x9's have a good sensitivity rating (93db) and relatively low power handling (60W RMS). I get it the stock 7" head unit is under powered for...

Perfect. Thank you!! Got myself a little project this weekend.

Hello, Been doing a ton of research and I still can’t figure this out. So, I have 6x9’s and 3.5’s being delivered Friday. What I’m wondering is: Will I be fine plugging the 6x9’s into the 4“ speaker wire or is there an inline crossover somewhere that will block higher frequency’s to the new...

I have some infinity 6x9's being delivered Friday. I just noticed your comment about cutting the wire to the tweeter. Did you do this to essentially bi-amplify your alpines? Is this necessary or will I be fine to just use the meta adapter and hook my new speakers up to existing 4" speaker wires...

Thanks for the advice. you saved me $90.

They do. So, maybe I'd be better off ordering another set of full range speakers for that spot in the bar?

Does anyone know if the non-alpine system has an inline crossover for the smaller speaker in the soundbar? I ordered 4" speakers for the soundbar and separate tweeters. Thanks.