Sponsored

Search results for query: hoist

Forum search Google search

  1. Awning hoist in garage

    I like this a lot. I use a harbor freight electric hoist to lift the RTT on and off the rack.

  2. Awning hoist in garage

    Used a Harken hoist that I got from a forum member for a good price . Works well lifting my 72” CVT 270 awning mounted on Yakima round bars with quick disconnect control towers. Not installed to drop it all the way to ground goes to 30” as I just back the Mojave in and set it on the RSI cap...

  3. Cold start rough idle and sometimes 303 code

    Good idea, I would swap the coil to one cylinder and the swap the injector to a different cylinder. Pulling the intake is not required to swap injectors on the right bank, there is enough flex in the fuel line connecting the two fuel rails to allow the injectors to be removed. I use...

  4. Cold start rough idle and sometimes 303 code

    Yeah, if you go to specific stations and do the homework. But how many do? How many assume "premium is better" and pump it in, while it may be no better than "regular". So if he uses Shell fuel........... (hard to find around here) 12.4 is low. If the batteries are fully charged and in good...

  5. Cold start rough idle and sometimes 303 code

    ...I can see spending an extra $4.00 for a half tank (CA diff. in price between 87 and 91 X 10 gal.), in addition to adding injector cleaner. I @Hoist has the battery voltage, when checked after the truck has been off for several hours, remained above 12.4? Just wondering if the root cause was...

  6. Cold start rough idle and sometimes 303 code

    Fuel injector cleaner isn't a bad idea depending on what fuel you buy. Premium? To me that's always a "why"? because octane doesn't do anything other than prevent detonation, which you don't have.

  7. Cold start rough idle and sometimes 303 code

    Likely etched in. Not sure but perhaps grade 1 or 2 is a size difference like they have historically done with parts.

  8. Cold start rough idle and sometimes 303 code

    Right now, all things are on the table since there's no other information to narrow it down. I would ask - has the coolant level dropped at all? If there's coolant getting into a cylinder(s), then it has to come from somewhere, meaning coolant going out, the level MUST drop the same amount...

  9. Cold start rough idle and sometimes 303 code

    Pull the valve cover and you can tell if there's a cam/follower issue. It's going to LOOK bad.

  10. Cold start rough idle and sometimes 303 code

    12.3 is getting low - low enough they should be charged. Even 12.65 isn't fully charged but might show that when all connected due to the load of the electronics.

  11. Cold start rough idle and sometimes 303 code

    You need to do a misfire count. That way you could see when it is happening.

  12. Cold start rough idle and sometimes 303 code

    I get that a lot too. Comes and goes. Seems to be a code stored if you try to start the vehicle and it has not yet picked up the RFID data from the FOB.

  13. New to Gladiator

    Did you use MOPAR OEM parts? It may be a fuel injector that is causing this. you may want to run some fuel injector cleaner through it in a tank full of gas. Then see if that clears it up.

  14. New to Gladiator

    Sorry to hear that. It is not a horrible job. Unfortunately the parts are hard to come by. Some have had more luck just letting the dealer do it. They seem to horde the parts for their customers. Hopefully you get the misfire squared away so you may enjoy your new toy. Maybe your misfire is not...

  15. Need contraption for back half hardtop lifting / holding

    Or just get a couple pulleys and a few eye screws and some rope and make ya one with a boat winch.

  16. Need contraption for back half hardtop lifting / holding

    Find a used Wrangler hardtop hoist on CL or FB Marketplace. I had a JKU. I have a Harken Hoister I recycled from that. I've seen the manual ones like I have for as little as $50 to the fully electric ones for $200-$400. I'm able to remove and replace my top by myself with ease.

  17. Need contraption for back half hardtop lifting / holding

    I really like this idea as I have the whole garage opener center setup as well. What do you think your cost was with materials and all?

  18. Need contraption for back half hardtop lifting / holding

    Yes , I understand about some having physical limitations and its all understandable, I aint got a perfect back myself. But yeah I only really needed my wife to align it really . I literally can lift the whole thing by myself. Last time I took it off and laid it in the grass ,I carried it back...

  19. Need contraption for back half hardtop lifting / holding

    I used to hang my JKU hardtop from the garage ceiling with a DIY hoist, then it lived on a picnic table on my patio until I sold it. But because the JT's hardtop is much smaller, when the weather cools off and I finally decide to remove it, it will just live in my garage, no fancy hoist, just...

  20. Need contraption for back half hardtop lifting / holding

    Lots of ways to do it….. We have a hoist setup on a trolly. Bought everything on Amazon and/or lowes.




Top