Well, this time around wasn't nearly as bad. I lifted the pieces up, and ran zip ties through the over rider holes and aligned the bolt holes with a drift while putting in the bolts. Much easier this way, but still a pain in the butt.
Alot of work for a simple project. I found out that mounting my solenoid box offset put the remote port directly in line with my LP6 lights.
I couldn't have aligned that better if I tried!
Off with the Arcus and winch to move the solenoid and re-route the cables. I told myself I would never...
Finally got around to putting in the KC Cyclone underhood lights, hopefully wont be needing them, but they are there in [email protected]
I cut circles out of the isolation pad to the light locations
Good spot for the switch, coming up will be the ARB air manifold in this location
I finally removed my 50" bar this weekend after many attempts to silence it, including the latest addition of the aerolidz cover. It cut down the noise a bit, but was still present.
I've come to the conclusion its impossible to quiet a light bar on top of the jeeps steep and flat windshield.
I'm thinking of putting L track rails, 2 along the bottom of the bed within the ribs. Should make tying down crap easier in the bed, rather than a spider web between the trail rails. Now, if I could just find some...
Are any of you experiencing rattles in your dash? I've been working on the wind noises like the above post, but now my dash rattle noise has become more noticeable. Sounds like its above the radio somewhere...
I tried the roof option, but way too noisy. Not so much wind noise, but the bar spanning the "floating" freedom panels would make the seals squeak nonstop.
Fits my 184 long skiis without issue.
Old/noisy setup for reference:
Let me know how that bezel works out, I considered that option as well, but wasnt sure how much it actually covered.
These days my tailgate is covered in snow anyways so it doesn't bother me much. Once spring hits I'll have to find a way to clean up my camera wrap job.
I wrapped my bezel with leftover vinyl, not the easiest. I was hoping to be able to separate the camera from the bezel and paint it, but it appears the camera body is some sort of rivet holding it to the bezel. I didn't want to push my luck at risk of breaking something and not being able to get...
I hit remote start from my warm hotel room and fired right up!
Everything worked great on the cold drive, thank god I got the heated seats & wheel! HVAC kept up great with the defrosting and heating, I was wearing a tshirt inside.
One thing I noticed is the floor got pretty damn cold, my feet...