OEM Rock sliders from a Rubicon
Trimmed slightly to ensure no rubbing
Comes with hardware, minus 1 bolt I misplaced -- this bolt might be on your jeep though, i dont recall when installing
Located in Darnestown, MD
Will not ship
I retrofitted LED projectors into mine, my thread is below. I did not detail step by step but some issues I had, etc. I have done a few HID retrofits in my previous JKs and using the LED projector was much easier to work with. That was the only reason I went that route. I prefer the output of...
Pretty surprised about that. Have you cleaned it up thoroughly and driven around to see if it's a constant leak or was just leftover from the install? If it's continually I'm sure OX will make it right and send new covers. Keep us posted
Got around to running the air lines and switches. Im using the S-Tech switches. I decided to mount my co2 bottle in the bed vs in the cab. This way I didnt have to run any extra lines or wires inside, made for a simple install. I need to clean it up a bit and tie back the air line in the bed...
Wanted to give people an update. I picked my JT up last night after gear/locker install. I had both front and rear done and I am going with Air Actuated.
My guy said install itself went smooth and easy with no issues. The only problem is at full droop the rear sway bar hits the air line thats...
im running 3" JKS springs (and some other parts) with 40" baja boss and kmc hex beadlocks. I had to chop the inside of my bumper a good bit to not rub, but its just temporary until i decide on a bumper. I also did chop my fenders at the same time