Search results

Thank you all VERY much for the suggestions. Meant to circle back sooner but a family member needed some help. Yes, I had removed the Torx bolt that's kinda the 'keeper' for the rotor/ hub when the wheel is off. Finally battled my way to a solution. Kept trying for the star adjuster and found...

The mention above about post-recall, is that "post-newest (2023) recall"? I'm not active on Facebook. Thanks

Stumped & frustrated and I'd welcome any help Doing a total refresh on my back brakes (new pads, rotors & parking/ e-brake shoes) Have past experience working on both disc and drum brakes, though it's been a couple of decades. Stumped at getting rotors "all the way off" I have the calipers...

Update.... Got a NAPA caliper this morning, ordering it online for local pickup with a 20% NEWYEAR discount through 1/7. Ordered it this AM and picked it up midday. As some of you suggested, this way I was able to eyeball it to make sure it was the right one. Looked in the box before leaving...

Thanks for the responses. Thankfully I'm able to borrow a different vehicle. Since starting this thread I also looked up the PowerStop calipers (L15100/l1501) on Summit and Summit lists these same calipers as fitting both a 2020 JT and a 2020 JLR - and the Summit photos for the L15100 which...

Hello all- I have a 2020 JT Sport S MT, owned new since 9/2019. Due to the general cluster_ _ _ _ of the last few years, and some specific clusters in my own circumstances, I have not been driving much. Only about 22.000 miles. I live in Vermont, land of heavily salted winter roads and lots...

This one is also way better, and easier to install, than a "usual" PL-259 but I think the one above with the clamp is sturdier and more reliable...

Don't remember what radio you are installing or what antenna connector on your radio is. But if you have a radio with a super-common "UHF" connector (with the ridges at the forward face of the threaded section on the radio) . . . . The overwhelming majority of "standard" "PL 259" UHF coaxial...

Yes. Unruly dynamics and solid front axle 4wd are "well known to one another" In the early 20-tens I drove a 1989 Ford F350 4x4 (leaf springs front and back) that I bought from a government surplus route that had only 12.000 (real) miles on it. I got it direct from a local government who'd...

Whether or not you have to do any modification to the soundbar with the Select Increments adapters will vary depending upon the magnet size and back depth (including the varying depth and contour of the basket/frame of the speaker) of the 6.5 driver you choose to use. The speakers that S.I...

I haven't had signs of failure or trouble from either the main or AUX battery. But I will be peeling into things right around the AUX battery to get to the passenger side firewall grommet to run 12+V for some audio wiring. So I would kick myself if I didn't replace the AUX battery, while I am...

Thank you - all- very much! I was concerned,. at minimum, that I'd have put a lot of strain on wiring (if the AUX battery conductors had not been sized to supply cranking current) and the PCR contacts "backfeeding" starting current in that direction. But from what I think I am seeing now that I...

Seeking input on this especially but not only from ShadowsPapa - but welcome other input also! I fouled up - the question is how bad and whether or how much damage I may have caused For background, this mistake is very unlike "usual me". I had COVID, back in the fall, got over the actual COVID...

Thanks XRayTech - I may want to run it closer in through the grab bar area if there's space, rather than out by the windshield frame in the way that this guy shows. I actually have "that" CB bar shown in the video that I may use to mount the transceiver control heads up near the visor. Main...

re- running wire through/ after removing the grab handle - can anyone (who has had it off and run wire there) please give me any approximate sense of how much space there is for wires underneath the cover? I plan to put two amateur radio (ham) mobile transceivers in, on an overhead MOLLE...

Glad that worked well!! - I have a set of pods and some Focal components to go in ... got sidelined with work schedule and other things that kind of pushed everything to the back burner

This is kind of a late reply- but... hopefully better late than never. There is nothing that would stop using new/aftermarket component speakers, utilizing the new component speakers' crossovers, with the Select Increments pods, in a non-Alpine system. The stock non-Alpine system basically has...

thanks Gatorized- I had to walk away from it for a while on Sunday, both because I'd become so tired and frustrated and because I had to get other things done. Not sure when I will have a further chance to take a go at it until maybe this weekend. Or maybe it's just time to take it to a tire shop...

Hoping that someone here has some kind of trick that I am not thinking of, that you can share, for fishing out a TPMS that is loose, down in a tire, that is still on a rim, without having to take the tire all the way off the rim? Long story sort of short ... I have a 2020 Gladiator Sport S...

My 5" is basically decent. Occasionally laggy at startup but that's the exception and not major. But the clock does lose time like it's got a hole in it. This TSB when I look it up seems to list JL but not Gladiator (I know that they are basically the same esp. as far as radio and related...