Search results

Kyle-I have the silver Overland here in Tulsa that I am looking to regear to 4.88 as well. Who are you using to install gears? Would love to connect some time. Scott

Also, the charging cradle is $450 range and I think I got it for 15% off. The Alpine Jeep bluetooth speaker was $350 range and I got it for $290's with coupon from Mopar. I will have nearly $750 in this setup and its a $295 option from Jeep.

You are correct in that it is not available and is currently back-ordered while the "part is being sourced with manufacturer" so whoever makes the cradle for Jeep hasn't made them available.

The factory option for the Alpine Bluetooth speaker is $295 and I paid $390 after my 15% MOPAR coupon was applied. Then I learned the existing cradle doesn't quite fit the speaker and doesn't charge it either so I just paid another $400 for the cradle that has wiring and charging contact...

I picked up my Alpine BT speaker at dealer today and it doesn't quite fit in the storage area. I saw your pic with cover removed and now remember the dealer asking if I needed the charging cradle and tray and I said "no". The correct answer was yes because its apparent now that you have to...

I added the American Flag decal so I went with the subtle outline so the hood didn't get too busy.

Added this last week

I added these today. I guess I'm used to seeing my Scramblers with their lettering and thought it just didn't seem right without it.

Got mine today but haven't installed it yet. I will upload pics once I do but it will likely be end of next week.

What is the cost? I am ready for a set

I ordered mine first week of May and it still show "in production" as of last week. I hope early June is accurate!!

Checking in from Tulsa. Mine shipped in May 6th and I purchased it May 7th from dealer. Been in and out of the shop for last couple of weeks getting lift, bumper, winch and lights. Love every minute I get to spend in it.

I have added the bumper, winch and lights earlier this week. Adding a 1" spacer to the front spring to get the front back up. The weight of the bumper and winch dropped it about 1/2" and and it already had a lot of rake so this will get it closer to even but still leave a little rake.

I dropped it off at 4 Wheel Parts in Tulsa yesterday for front bumper, 7" LED lights, winch and A pillar brackets with 4" LED lights. Once I get it back, I think I am going to finish it off with black hood panel decal to cover the center of the hood and break up the silver and then the cherry...

That will look good. I have a billet silver Overland and want the black in Gladiator font to keep with my blackout look.

According to dealer I ordered mine from in early May, the Mopar sun top and folding soft tonneau cover are both "in development" according to the dealer parts site.

I went with GLADI8R

I ordered this Gladiator decal in black from Pixie a couple of weeks ago and still haven't seen it yet. I guess I need to check in with Don too! I think the Gladiator will look great in the same font as the rocker panel decal.

If you look at the fenders, they sit higher on a Rubicon as the bottom of the hood meets the fender. My Overland front flares set well below the hood so you are correct. I believe someone has posted actual measurements of the Overland versus the Rubicon on clearance and there was a one inch...