Search results

Guess I've past my time as had right bank replaced under warranty at around 20,000 miles and last week with 51,000 miles right bank went bad again. Engine light on and sounds like a diesel. wish they would figure out issues this will get costly.

Looking to see if any others have had this issue? 2020 JTR with just over 14,000 miles, started it up and ran a little rough at first and had had no reading on engine temp gauge. Shut it off then restarted moment later and temp gauge started working but engine light came on. checked codes and...

Just seen that JCR is making a replacement for the factory nonlockable . About 1/2 the cost of replacing with the factory lockable one.

Left mine on and mechanic bent the crap out of it getting it off and could not be used. suggest taking it off as usually the mechanic doing warranty work is not the best (brightest).

http://www.dietechoffroad.com/products/jlmirrorbracket.htm

Sorry that didn't work. Hopefully this does.http://www.dietechoffroad.com/products/images/mirrorbracketjl_full.jpg

http://www.dietechoffroad.com/products/images/mirrorbracketjl_full.jpg These are supposed to be avaliable soon

Correct. Cut the arm bracket off installed on hinge and clamped into place removed and tacked and then test fit before fulling welding in. Only problem is it came powder coated, just sprayed with flat black and matched pretty close and its on back side so hard to see. Mirrors work good. Just sit...

Added the Die-Tech mirror mounts for the JK, had to cut the bracket that mounts behind door hinge bracket and weld on in different place. Work out good. Way to cold to take for a test drive.

fortec4x4.com

Installed mirror brackets for when doors are off. DIE-TECH mounts for a JK just changed the one bracket that goes behind hinge bolt.

Finished installing Warn 12s winch and wiring up also started installing GMRS & Ham radios today.

Made A lift for removing my hard top, and removed my hard top. Will install soft top tomorrow ran out of time today.

I did all that and just added the Steersmarts draglink and that really helped. Waiting for C.C. Bill to cool down and will install the Steersmarts tie rod assembly.

Mine had the dead spot when centered. Buddies 07 JKU with 250K on drove better then mine brand new.

Added Yeti Steersmarts drag ling. With this a new steering box, the Synergy sector shaft brace and Falcon stabilizer it steers like it should.

I used Maximus 3 guard with there light mounting taps that are for THE Jeep Steel bumper https://maximus-3.com

And it has a two year warranty.

Almost $650 with few pints Mopar electric power steering fluid and core. Went from being hard to keep it in one lane with both hands to one hand driving without much effort. Not perfect but much better.