Search results

Yes it is the explorer from before they released the contour. I will get some more pics tomorrow.

Aluminum steering knuckles from Rubicon - $650 obo Took these off at @16K miles to replace with high steer knuckles Local pickup Houston Area - will consider shipping but buyer pays shipping cost

For sale The Bush Company 270 XT Awning Mk2 - $750 Local pickup Houston area

Alucab Canopy for Gladiator with 4 load bars, ammo slide and cupboard interior lights have been upgraded to national luna touch light white/red Local Pickup Houston Area $2500 - obo

I have not done much, but I have not been wheeling in very dusty areas. I did put some sealant between the headboard and alu-cab on either side where it does not sit flush with the top of the bed as water was coming in there every time I drove in the rain. most of teh other holes were already...

I did not put the antenna under the dash, I ran the antenna cable up the A pillar and put the antenna above the passengers sun visor. I needed this adapter: Adapter And use this antenna: Antenna The reception is OK, but once I get out of town it drops off earlier than the factory antenna...

I got it from a local timber merchant, had to call around to find one that had 5x5 Baltic birch

I was told that at some point in the 2021 production year Jeep changed the wiring. It is mentioned in the new install video from Genesis. May even depend on what options you have on the Jeep.

This last weekend I managed to get a couple of days wheeling in and noticed something while in 4 low, just not sure if these are normal as it is my first Jeep. This was my first proper off-road trip. 1) At low RPM (about 1000) it will surge to 1500 and the drop back to 1000 repeatedly if I am...

Yep I have the Alu-Cab canopy

The power is just a Stinger fuse Block for the power to the bed and then a distribution block for the ground below that was installed by a local shop. Still need to wire up the switch panel and fuses for the lights and other loads. 1/0GA HIGH POWER MIDI FUSE BLOCK (2) 1/0GA INPUT TO (3) 4GA...

Thanks for the quick reply Benny. I managed to find one at a salvage yard today.

Hi is it possible to get just the positive battery terminal clamp or do you need the whole wiring loom? The little wedge to tighten the clamp fallout in two piece when I loosened that clamp. Thanks

Thanks I will give that a try. So far online it looks like you have to get the whole positive battery wiring loom. Yep it looks like the little wedge has a groove in the top exactly where it split, so over tightening may well cause it to split.

Hey does anyone know if you can get just the clamp for the positive battery terminal? and if so what's the part number? Or is there another brand that I can get that is decent and wont melt under load :) Was removing the clamps to test the battery and the tensioner part just fell out., must...

The anvil overland bar is well made, I replaced my 67/Bullletpoint setup with it and so far am happy with it. 67 designs rail base was great, the arms were about the same from both companies and would work themselves loose enough for the phone holder to move when removing the phone. Even using...

Another option if you have the trailer wiring. The place that installed it for me wired the brake light to the trailer wiring, when I asked about that they said it was more consistent than the tail light wiring.

When I was looking for a option for fuel can outside the canopy, I did come across a cowl mounted option that had either rotopax or jerry can options. Think it was by Morryde or something like that