Search results

Well, i installed the dobson hd rear springs with a teraflex 1.5" spacer to the 3.5" lift with 315/70 r17 tires on stock rubicon rims. This gives a slight forward rake when unloaded and a level stance when fully dressed out for overlanding. The gladdy weighs around 6700lbs when fully loaded. I...

Teamblkdog, i just bought 2 heating pads with adjustable thermostats. One for my battery and one for my propane tank. I was out last week in 26 degree weather. Cold not get my dickson 9000 to light up. I got to Virginia the next day in 44 degree weather and sh fired right up. I got this rig...

Well, i am installing the dobson 3" hd reae springs tomorrow. I will let everyone know what happens. Also, I have taked via message boarx with crazycooter and he sounds like he has a great setup for the JT with the clayton hd springs.

I think because the battery shut down the redarc AI could not fing a source of power. Once I brought the battery temp back up the redarc automatically came back up. Working as designed. If i go to a 200 amp/hr system i will go with battleborn heated batteries.

Thx guys. I told my builder that i would be using my rig in the mountains of colorado in the winter. He suggested lithium blue 100 amp/hr bluetooth capable battery. This past week the temps dropped below 25 degrees and my redarc system shutdown due to the battry temp went below 32 degrees. This...

Thx, i will look i to it.?

I am curios what the group does to keep their lithium battery above 32 degrees. Temps in texas dropped to 15 degrees and i learned that my setup isolates the battery below 32 degrees. My cfx 55im does not draw enough current to keep the battery warm.

Do you have insight on a route to take? Who would you suggest i talk to?

I installed a 3 1/2 teraflex lift with 8 ir control arms. Installer said the teraflex rear springs were good but when we lowered the jeep the rear springs just do not seem to support the 6400 load weight properly. I still have a 1.5" sag. I am now waiting on dobson 3" hd 660 lbs coils. I have a...

Well, i bit the bullet and bought the teraflex st3 with adjustable control arms, falcon 3.3 ajustable shocks, and the extended rear dumafluchy for 16" articulation. You can tell i am a noob.

Sir, how do you like your AEV suspension?

Fungshui, what suspension are you looking at. I too am in thd same boat. Body roll is annoying to passenger (wife).

Time to replace the 285's with 315's on the stock rims?

Thx for the input. The 3" HD dobinson springs on the rear only. Unfortunately, this is not a simple one maufacture fits all process. The sway does not bother me as much as it does the wife. But it needs to be fixed.

Are you using the aev dualsport suspension with dobinson springs (front, rear, or both) and adjustable fox 2.5 shocks? Which springs did you use? The 3" or 2" rated at 800 to 1400lbs?

I used the same setup as Moriarty. I also used a 1" plastic plug to cover the access hole.

I mounted the redarc manager30 on the molle panels situating them to leave room For a 2000watt inverter. I then took the vehicle to an installer to hard wire the system for dc, solar and shore power.

There is enough room to mount the 2000w inverter on the center panel. I do not have the funds for it yet. The third panel is for a water heater...

The compressor chuck is on the back right.

Here is the photo of the redarc setup