Search results

Update: Decided to wire up the fad for manual control. Used this thread as a guide for the controls: https://www.jlwranglerforums.com/forum/threads/how-to-manually-control-the-fad.42710/page-3 Took me a while to figure out that for whatever reason on my gladiator pin 2 and 3 are swapped so I...

Were you able to buy the FAD harness or the factory locker harness? This is for the FAD and appears to be a part of the main chasis harness. While I could replace it, it looks is super involved and probably not accessible without cab off not to mention its 500...

UPDATE It’s worse than I thought. I finally got a chance ti poke around with a multi meter and check for the intermittent short. I was able to confirm a good ground at the connector then proved the rest of the connector for continuity to ground. Nothing; I couldn’t replicate the short seven...

I have a sport so no factory locker harness routed mine myself up with the breather tube. Do you know if the front locker harness you are referring to is routed with the FAD wire? That seems to be the only electronic 4wd stuff the computer knows about so I'm not sure what else it would be though...

This is quite the treasure trove! Defiantly good resources for anyone looking to trouble shoot things themself before going to the dealer and being out a rig for days.

Thank you so much this certainly gives me some good direction. FAD plug was the first place I checked in case it was dirty. I cleaned contacts and reassembled with dielectric grease, but the problem has persisted. Will give the wiring a thorough inspection and do some Multi-meter probing if I...

So my service 4WD light is flashing on and off irregularly (2020 Gladiator sport S). I have an ECRI and pulled those two code can’t find anything on what they are does anyone know what they mean? C146313 C147B14 I have had this problem 2 years and as many have reported the dealership kinda...

I think it would so long as the canopy you get has an inner lip not an outer lip. The first gen Tacoma caps seem to just sit on the rails and have a lid that sits inside the bed. Newer caps I’ve seen has the lip on the outside that falls down over the outer edge with the body line and that...

Thanks for the tip I’ll definitely take a look at this as the cap paint could use some love!

Yeh happy to! Everything is available at Home Depot and doable for a few hundred including the boxes. So I didn’t have factory trail rails so I made my own it’s the deep unistrut from Home Depot paired black and thread into factor mounting holes. The threaded holes are M6 I believe. The plates...

I am currently just using regular cap clamps bought on Amazon. No modifications needed just had to sneak them in between my pack out mounts

So for a long time I’ve wondered if a camper shell from a first gen Tacoma with the 5 foot bed would fit a gladiator. The bed dimensions are basically identical but I’ve never see anyone do this. Well this past week I finally bit the bullet and picked one up off marketplace. As luck would have...