California 1/4" or 3/8" thick steel bumper spacers

[svc707]

Any interest in 1/4" spacers to push out your bumpers for clearance issues? I made these to push out my bumper to relieve some of the contact I had using the Arcus front bumper package and the HF Bandland Apex winch. I went off the bolt pattern from the supplied hooks (which are not equally spaces) but I will make the holes larger to allow for more adjustments. I'll do these for $35 shipped (pair) if anyone needs some too.

I can do 3/8" thick, $45 shipped for the pair.

Thanks
Steve

Sponsored

 

[Hootbro]

I would be down for a set.

 

[svc707]

Just finished three pairs ready to ship. PM me for more details and I'll ship out tomorrow.

Thanks
Steve

 

[svc707]

1 more pair available. I'll cut more next week.

Thanks,
Steve

 

[Vballer16]

Im interested in a set. i have the same bumper. Did you actually put the plates on the outside of the winch plate?

 

[svc707]

Im interested in a set. i have the same bumper. Did you actually put the plates on the outside of the winch plate?

Yes. I put after winch mount. Between winch plate and hook plate.

 

[svc707]

I cut 6 more pairs.

 

[Hootbro]

Just a friendly plug that I got my set from svc707 within a week on the opposite coast. As pictured, very well packed and great quality.

 

[svc707]

More sets ready to go

 

[svc707]

PM for more details. I have 4 sets left from this run ready to ship.

 

[svc707]

Plates are ready to ship.

 

[KB34]

Plates are ready to ship.

I’m down for a set.

 

[svc707]

Bump....

 

[svc707]

Bump...

 

[atxatxatx]

I'm down for a set,

Sponsored