kevman65
Well-Known Member
- Thread starter
- #1
When I installed my front bumper and winch, I used sticky zip tie blocks to anchor the fog light harness.
Did a couple of loops to take up slack and put the zip tie blocks in those locations.
Well, I didn't pay attention to where things were when I mounted winch and tightened everything down.
Pinched the driver side lead between winch and bumper, drivers fog went out this week and I just traced the problem down.
Much cheaper than I thought the problem was, single LED fog is $173+.
So don't be a dum bass, pay attention to the wiring.
Wiring harness is fairly cheap, shipping not so much, but twas my own fault.
Did a couple of loops to take up slack and put the zip tie blocks in those locations.
Well, I didn't pay attention to where things were when I mounted winch and tightened everything down.
Pinched the driver side lead between winch and bumper, drivers fog went out this week and I just traced the problem down.
Much cheaper than I thought the problem was, single LED fog is $173+.
So don't be a dum bass, pay attention to the wiring.
Wiring harness is fairly cheap, shipping not so much, but twas my own fault.
Sponsored