kevman65
Well-Known Member
- Thread starter
- #1
Not going in depth, cut and dry and has been covered elsewhere.
Main thing I want to mention, after seeing someone else say they galled some threads on a bolt, the top outside mounting holes on the frame horns might need to be drilled out. Both of mine the ID of the backside was smaller than the front. Ran a 1/2" drill bit through both of them after discovering they were snug.
Removing stock plastic bumper. Started to take all the little screws out and noticed the back side of all the Christmas trees were sticking through. Dug through my tool box and found a pair of long, narrow side cuts and clipped them all off and snaked the fog light wiring out.
That's all I've got, other than 2 sets of hands would make it easier.
Main thing I want to mention, after seeing someone else say they galled some threads on a bolt, the top outside mounting holes on the frame horns might need to be drilled out. Both of mine the ID of the backside was smaller than the front. Ran a 1/2" drill bit through both of them after discovering they were snug.
Removing stock plastic bumper. Started to take all the little screws out and noticed the back side of all the Christmas trees were sticking through. Dug through my tool box and found a pair of long, narrow side cuts and clipped them all off and snaked the fog light wiring out.
That's all I've got, other than 2 sets of hands would make it easier.
Sponsored