SwampNut
Well-Known Member
- Thread starter
- #1
I'd like to install a DEI microwave motion sensor, and wire it to the factory system, for protection when the top and doors are off. Since I have the Sirius Guardian package, it would alert me on my phone. I'm thinking that I'd wire the sensor to the hood pin, so that it basically thinks someone opened the hood. (I have the Tazer JL set to alarm on hood opening.). Wondering if anyone has done this, and/or has ideas about it.
Potential problems:
While driving around, it will sense me moving, and basically "open" the hood. Will I get warnings on the dash? That would be annoying. The solution would be to figure out a way to only arm it when the alarm is armed, if that's even possible. No, a manual switch would not work for me, I'd forget it.
The Tazer translates the hood opening to a panic alarm. Will that then go to Sirius? Need to test this later when I have some time.
Other thoughts?
Potential problems:
While driving around, it will sense me moving, and basically "open" the hood. Will I get warnings on the dash? That would be annoying. The solution would be to figure out a way to only arm it when the alarm is armed, if that's even possible. No, a manual switch would not work for me, I'd forget it.
The Tazer translates the hood opening to a panic alarm. Will that then go to Sirius? Need to test this later when I have some time.
Other thoughts?
Sponsored