MotoBilt Rear Bumper - Install | Video | AMAZING BUMPER

[Wizzard005]

Hey Everyone,

We have been waiting for a long time to get our hands on this bumper! This bumps checks off most our boxes and here's why!

Install Video is Here:



Wrap Around Design:

Doesn't hang down too much

Follows the lines of the JT:

Spots for Lights:

Looks like it can take a beating!

If anyone here questions, shoot us a message! If your looking of a bumper, this one rocks. Only thing its missing is Tire Carrier, however we are going to order one and have it welded on, there are a few online for 200 - 500ish, with the cost of welding, its still way less then what is out there currently.

Sponsored

 

[Wizzard005]

Video is up!

 

[Wizzard005]

Final Coat of Paint has been done... and Diode Dynamics SS3 PODs Installed

 

[Jamesrich82]

My rear bumper shows up today and it’s going to head down to power coating. I’m trying to get everything setup and ready to do the install, but the only question is I’m not sure, the lower plastic trim piece just above where the old rock sliders mount, did you remove that or leave it?

 

[Wizzard005]

My rear bumper shows up today and it’s going to head down to power coating. I’m trying to get everything setup and ready to do the install, but the only question is I’m not sure, the lower plastic trim piece just above where the old rock sliders mount, did you remove that or leave it?

Getting a new bumper is exciting. It’s going to look good after you powder coat it. The side plastic pieces don’t come off after you remove the rock sliders. The bumper covers it. Did you order the extra frame mounts?

 

[GDOLBOI]

Do you guys happen to have a picture from directly behind it??

 

[GDOLBOI]

Do you guys happen to have a picture from directly behind it??

???

 

[KayboKabuk]

What backup lights did you use? How hard were they to install and wire in?

Sponsored