Sold: Arizona Oracle Oculus Bi LED - $360 shipped

[tonywin]

Selling an excellent condition set of Oracle Oculus Bi LED head lamps in graphite metallic. Ran these on my JT for 10 months with no issues whatsoever.. Halos are bright, LED cutoff is excellent, and no condensation issues. Only reason I'm selling is I'm trying out some DV8 OEM clones.

These are NOT the heated or RGB colorshift models.

$360 shipped in the CONUS.

Sponsored

 

[RogueJT]

Interested. These are plug and play correct?

 

[tonywin]

Interested. These are plug and play correct?

That’s correct. I don’t believe you even have to use a Tazer either. Works for halogen or LEDs without throwing a code.

 

[RogueJT]

I have a tazer so worst case scenario it’s there. You got any pictures of light output at night by chance?

 

[tonywin]

I have a tazer so worst case scenario it’s there. You got any pictures of light output at night by chance?

I don’t unfortunately l as I search through my phone photos. But I did find this picture on the JL forums and it’s exactly like the picture with a little step on the left side.

 

[NCSteve83]

I have a tazer so worst case scenario it’s there. You got any pictures of light output at night by chance?

I have some pics, here ya go

 

[mog]

Interested. These are plug and play correct?

Yup, I installed a pair of these in my non-LED Rubicon with zero issues. The most you have to do is if you want the halos is to run the provided wire to tap into Fuse 52 in the fuse box (everything is in the kit). Super easy install and a world of difference better than the stock non-LEDs.

 

[tonywin]

I have some pics, here ya go

Thanks for sharing, that looks great!

Yup, I installed a pair of these in my non-LED Rubicon with zero issues. The most you have to do is if you want the halos is to run the provided wire to tap into Fuse 52 in the fuse box (everything is in the kit). Super easy install and a world of difference better than the stock non-LEDs.

Yes, very easy to install! Literally took less than 20 minutes. Longest part is cable management and making it clean.

 

[RogueJT]

@tonywin I’m assuming you have all the necessary cables still correct?

 

[tonywin]

@tonywin I’m assuming you have all the necessary cables still correct?

@RogueJT I sure do. Everything included for it to run properly including the halos.

 

[RogueJT]

PM sent

 

[tonywin]

Sold! Thanks @RogueJT

 

[mog]

Congratulation @RogueJT, you will love the change. Check out the Quadratec video for the installation. Do what he did and extend the wire for the Halo rings a little longer so you can enter the fuse panel on the right side where it is open. The adapter that goes in the fuse slot has two fuse holder slots, one for the 15 amp fuse that runs the cig light and the 'extra' that will run the Halos, so you need two fuses in that. 5 amps is more than enough for the Halos. If you think you will add 'Prerunner' lights in the future, that wire for the Halos is a great place to get power from as the LED Prerunner lights use very few amps.

 

[RogueJT]

@tonywin thanks again! Got the lights installed today and already loving the look. Install was as easy as everyone made it sound. Now to wait till dark to see the brightness

Sponsored