BringTheLightnin
Well-Known Member
- First Name
- Logan
- Joined
- Jan 6, 2023
- Threads
- 15
- Messages
- 174
- Reaction score
- 95
- Location
- Greensboro, NC
- Vehicle(s)
- Jeep Gladiator Sport
- Thread starter
- #1
So I took my Jeep to Windrock about a month ago and it overheated twice on me in 4HI so I used the tazer to keep the fan going on high and it did fine the rest of the time. Hasn't done it again until yesterday on my way home from work just as I pulled up to my house in 2HI. No warning just bam overheating. Check engine light came on and the codes were P0480 & U0168. I looked them up but didn't find any clues to how to fix this. I'm assuming the reason it overheated those couple times is the fan was not spinning at all as I had to manually turn it until it decided it wanted to go. Any advice? I might take it to the dealer after I pull the pulsar off as it is under warranty still but the codes cleared the 2nd time I started it after that.
Sponsored