Parts ordered to make a 4 Tire Inflation system

[XraytecH]

Parts ordered to make a 4 Tire Inflation system

All parts sourced from Amazon

Sponsored

 

[XraytecH]

Waiting on a couple more bits...

 

[bastage]

Snap.. you went fancy.. I went with hybrid line too, but I went cheap with it. Still ended up spending a pretty penny on mine. Heres the thread I did. https://www.jeepgladiatorforum.com/forum/threads/my-take-on-a-4-tire-air-up-down-system.46982/

of note.. I have not been out at all without people commenting on the setup. The air down process is stupid fast & airing up I end up being well over twice as fast as most other folks with the set it once & walk away nature & the extra fitting to connect the 2nd compressor.

 

[XraytecH]

Yeah

I could have bought two Speedflates with how much I spent. But I enjoy the journey not the destination.

 

[bastage]

Yeah

I could have bought two Speedflates with how much I spent. But I enjoy the journey not the destination.

The speedflate nor any other pre done system served what I wanted. I was already using 2 compressors to fill up. So I wanted to be able to keep doing just that. The only real thing I dont like is that I made all the lines too long. That will be fixed whenever I get around to it though. Just gotta take the leads off the T's running front & back & then take a few feet, re-attach & then add new heat shrink to keep it looking pretty.

 

[XraytecH]

 

[brianinca]

Makes me feel less bad about pushing the easy button, but I get the imperative to roll your own. I can never do without a 4 tire system, now.

Yeah

I could have bought two Speedflates with how much I spent. But I enjoy the journey not the destination.

 

[Sportsbiz]

Yeah

I could have bought two Speedflates with how much I spent. But I enjoy the journey not the destination.

I have a Speedflate, and still want to build one of my own for the reason you state. Good on ya for going high end too!

 

[XraytecH]

Works but with one problem, actually 4. The valve stems on my wheels point inward towards the hub. Valves stems are protected from being snapped off but are nearly impossible to get a straight locking air chuck on them, so I had to use 45° angle air chuck. These chucks don't hold a seal very well so I'm working on a fix.

 

[XraytecH]

More bits coming

 

[bastage]

Those air chicks are far better then normal ones. I don’t think you will want or need the 45’s with those and the hybrid hose. Pretty much you just point and push and with 45’s you will need to pay attention to the hose angle and turn it the right direction.

edit: I just looked at your vehicle showcase. Only one pic can I spot what looks like the valve in your wheels and it looks to be in a very stupid place. So if I’m seeing it right I totally get the 45’s now.

 

[XraytecH]

Final revision works a treat now with the right chucks.

 

[KX L]

Seriously impressed.

Sponsored