Roof leak in back

[jac04]

Before I install the rubber/silicone trim (it arrived a few weeks ago)... is it recommended to get some silicone sealer in there as well?

I would not bother. It isn't needed if the tube fits well and it will only make a mess.

Sponsored

 

[wachuko]

I would not bother. It isn't needed if the tube fits well and it will only make a mess.

The rubber tubing will eventually need replaced due to sun damage.
So keep that in mind with whatever you put under the tubing that may glue it in place.

Thank you. No silicone sealant then

 

[Maximus Gladius]

Before I install the rubber/silicone trim (it arrived a few weeks ago)... is it recommended to get some silicone sealer in there as well?

Rubber and silicone tubing are two very different materials. Rubber will crack and dry out. Buy the silicone tubing and install that. See how that lives up to the elements and decide then if you want to seal the gap in with caulking. My silicone tubing stood up to the sun and weather this summer and now I get to see how it’ll take the winter temps. You can always decide later to use caulking but that wouldn’t be my first choice.

 

[JRobes]

Before I install the rubber/silicone trim (it arrived a few weeks ago)... is it recommended to get some silicone sealer in there as well?

I wouldn't put any permanent non-factory goop/adhesive/silicone in there while you're under warranty, as that'll just give the dealership a reason to deny any future claims and blame it on you.

Just try the hose and if it fails, bring it back for another warranty replacement just before your warranty ends.

 

[wachuko]

Message received. I will clean everything well and only install the silicone hose air hose.

Thank you all!

 

[jac04]

Rubber will crack and dry out.

I used Gates automotive rubber vacuum hose when I did mine. It's been through 3 summers and 2 winters without any signs whatsoever of deterioration. With that said, I think if I had to do it again I would try the silicone hose because it is typically lower durometer (softer) and likely easier to install.

Sponsored