viny graphics on the gladiator

[vance]

I still have not found a design that suits the gladiator, tried this one with spear but its repetition of the word gladiator
still looking, maybe something on the backwindow

Sponsored

 

[ShayneG]

Just added these to my Gladiator hood and bed...

 

[JP1]

@Pat2Alaska
Hook this guy up.

@vance
Check out Pat's build.

 

[ShayneG]

Oh....and custom leather interior...

 

[ShayneG]

@Pat2Alaska
Hook this guy up.

@vance
Check out Pat's build.

Custom design by Illusions Wraps in Fredericksburg, VA

 

[LiftedrubiconJT]

Custom design by Illusions Wraps in Fredericksburg, VA

Where did you get your seats done at? Was the hood wrap pretty reasonable? I’m not far from Fredericksburg

 

[Pat2Alaska]

@Pat2Alaska
Hook this guy up.

@vance
Check out Pat's build.

 

[Unforgiven77]

I went with hood decals. Matte Black on Black.

 

[LiftedrubiconJT]

Custom design by Illusions Wraps in Fredericksburg, VA

Was that you in manassas today shayne? Decals look good!

 

[Oasis Supernova]

Here are all mine I designed and made myself.

 

[Eazye]

Added the “matching” hood and vent decals....

 

[S&S]

a small company out of Post Falls Idaho did this for me

 

[txGlad]

Added the “matching” hood and vent decals....

These really look good. Where did you purchase them?

 

[Eazye]

These really look good. Where did you purchase them?

The hood and the side vent are both from pixdecal.com. Both are a 2 piece with the red being a primary layer and the flat black being a secondary layer. Using a soapy water solution and a felt covered squeegee, they were super easy to install. It says it’s difficult but my wife and me, with ZERO experience, did it on the hood perfectly. The vents were harder, Because I did it in the cold (below 40 degrees) in the garage. I used a hair dryer to heat the metal and the decal after install.

 

[Eazye]

The vents are easy to remove but there is a good chance you break the tabs. For $20 buy brand new ones and just put those on.

Sponsored