Weathertech Mud Flaps... anyone liking these?

[mmatthie]

Anyone liking these? I have aftermarket wheels..."stick out" factor is about 3"...curious if these would cover something that much outside of the fenders.

Thoughts?

Sponsored

 

[Mac]

IMO mud flaps do not look right on Jeeps, 3” is pretty far outside the fenders may have to custom make some, just get universal ones and mount them further out

 

[deuce]

We have Rok Blokz on ours. They make different sizes. Top quality and easy to install. Removable too.

https://rokblokz.com/collections/jeep-mud-flaps/Gladiator

 

[Canada g]

I installed those on my stock rubicon and do the job. Big difference with and without.

 

[Ohio JKU]

I installed weather techs on my jt Willys (see thread) and they look and work good.

In my opinion, these would not cover 3” outside the fender. They aren’t As big but that can be good in that they don’t stick out/ look bad....

They do a very good job on the mud terrains that come on the willys.

 

[johnparjr]

RokBlokz for the win

 

[kevman65]

I have the Weather Tech's on my Rubi.

They knocked the kick up down significantly, but not completely and I have less tire poke than you.

I would advise going with the Rok Blokz XL

 

[Dwayne]

These are the Rokblokz - long. They work great.

 

[marcwithac]

I have the Mopar ones. I wanted to see what the weathertechs were like in comparison. Turns out they're shorter than the Mopar and not quite as wide.

 

[IamAlan]

I installed weather techs on my jt Willys (see thread) and they look and work good.

In my opinion, these would not cover 3” outside the fender. They aren’t As big but that can be good in that they don’t stick out/ look bad....

They do a very good job on the mud terrains that come on the willys.

Which Weather Tech part numbers did you get for the Willys? I think they're #110097 and 120113 but For some reason, I can't seem to nail it down.
Thanks in advance.

 

[Ohio JKU]

Yes, parts numbers below

weathertech fit willys, with the factory rock rails: received and successfully installed as of 1/6/21:

“front And rear kit: 110097-120113”

these are the hard plastic, look and feel like the same black plastic as the fender....

 

[Unkiebunk045]

i just installed these on mine—one thing about the directions that they don’t mention is that on the front ones their are two different size clips and hex head screws. i struggled for a while getting the clips on the lower pieces before i realized it.

also the push connector is a pain, i broke both of them, prob not any issue, just still sucks.

the rears are super easy—even with all the issues took about 60-75minutes for me.

left front took 45 while i figured out the different size hex heads as well as realizing the clips were all different; 15 for the right front and then 5-10 on each rear.

 

[howerch]

Just installed on my truck. They look great. I like the fit on the WeatherTech. I have always loved WeatherTech products.

 

[GA D90]

I put them on my JTR when I saw how much salt &sand was kicking across the side, work really well. Just have them on the front, blend in well. Once iI start using the truck more off road , easy enough to remove, and put back on in the winter.

Sponsored