What did you do TO your Gladiator today? [ADMIN WARNING: NO POLITICS]

[Sandbox20]

That's a nice piece in the background ...

Thanks...1980 CJ5

Sponsored

 

[Snowdogyyz]

New Jeep slush mats, cup holder rubber coasters and new antenna.

 

[Buzzlb]

Got the Rubicon take-off, ON!

 

[DirtyD]

Accidentally posted this in the "with" thread... put new shoes on her. Mickey Thompson ATZ in 315/70r17.... FedEx should be bringing my step bars today as well.

 

[Boss Hog]

Installed LED Bar on Overrider Bar

Mods to date:
R/C 3.5" Lift
XFX 20"x 10" Wheels
Fury 37x12.50 R20LT Tires
N-Fab RKR Rock Rails
Sprayed in Bedliner
@Quadratec Full Width Aluminum Brute Strength Bumper
@Quadratec Aluminum Front Sway Bar Skid Plate
Air Lift 1000 Rear Bags
WeatherTech Floor Liners
Overrider LED Light Bar
Vent Visors

Think I'm gonna be done for awhile

 

[Hosstyle]

Accidentally posted this in the "with" thread... put new shoes on her. Mickey Thompson ATZ in 315/70r17.... FedEx should be bringing my step bars today as well.

did you have to lift to get this size tire? Is it a Sort with max towing?

 

[MeanMachine]

Installed a Warn Low Grill Guard today. I am on the fence whether to keep it or not. It is good quality, just not sure if I like the look or the view from trail cam. I have time to decide. I want to mount a set of KC Hilite Pro6 lights to the bumper, so that would further impede the trail cam’s view of a direct wheel placement. Decisions, decisions, decisions...

appears to have 6.5-inches of clearance between bumper and bottom of Grill Guard

I have 4.5 VisionX Cannon lights under the same guard - looks great, but it does impede the camera close in

 

[DirtyD]

And the steps are in and on....

 

[DirtyD]

did you have to lift to get this size tire? Is it a Sport with max towing?

I put a 1.5 inch level on a few months ago, it is a Sport non-max tow (3.73), looking at re-gearing in a few months.

 

[Hosstyle]

so just lifted the front? No issues running those tires with those gears?

 

[DirtyD]

Lifted the front 1.5, removed the filler panels between the bumper and fender. No issues, no rub, but also not rock crawling. As for the gears, I only have about 6 miles or so on these tires. Jury is still out. If I regear probably going to go 4.56, that puts me a hair over stock RPMs at 75 and i have no interest in trussing and replacing axles to run 37s safely.

 

[TRI-JAB]

I have 4.5 VisionX Cannon lights under the same guard - looks great, but it does impede the camera close in

Can you post a pic of the front of your JT with the lights and a pic of what it looks like through the Trail Cam? Thanks!

 

[mazeppa]

Diamondback SE install. A couple quirks but happy with the product overall. Took me all afternoon but not like I'm picky about alignment or anything...

Just finished my Diamondback HD install. Going to readjust the rear cover latches again tomorrow. Install time was about 2 hours by myself. Ordered 2Dec19, delivered 13Dec19 (today). I was initially going to get the SE that would have been more than adequate for my needs and usage, but for just $400.00 difference went with the HD cover that is way overkill for the JT bed rails support capacity.

Damn Styrofoam packing, little Styrofoam BBs all over the place.

 

[MarineHawk]

Installed LED Bar on Overrider Bar

Mods to date:
R/C 3.5" Lift
XFX 20"x 10" Wheels
Fury 37x12.50 R20LT Tires
N-Fab RKR Rock Rails
Sprayed in Bedliner
@Quadratec Full Width Aluminum Brute Strength Bumper
@Quadratec Aluminum Front Sway Bar Skid Plate
Air Lift 1000 Rear Bags
WeatherTech Floor Liners
Overrider LED Light Bar
Vent Visors

Think I'm gonna be done for awhile

Do you have enough air getting to your radiator?

 

[Proximo]

Do you have enough air getting to your radiator?

Sponsored