I havent heard any rattling at all and while it is an expensive cover you get what you pay for...the drainage system and water seals are solid on this thing. I got got yesterday in down pour with allJust curious. Do these type of bed covers rattle while the truck is in motion? Do they loosen up over time and rattle? Thanks.
100x better!
Its the little things....like changing the silver accent in the grill
Looks good, now it's time to do the silver trim on front bumper.
Its the little things....like changing the silver accent in the grill
It appears there is a version meant to be used with a drill driver and a manual hand crank version. Anyone able to find info on the latter?Dewalt Impact Ready right angle drive. Part # DWARA120.
I leave the door nuts off too. As for the top I just hand wrench them....takes like 2 minutes.I just use a basic drill. I also leave the screws out of the doors so I can easily pull them off. So, the only thing I need to unscrew is the 8 bolts for he hardtop. Again, I just use a standard drill. Works great and super fast.
I plan on doing the TAT next summer, where are you picking it up from? Are you planning on doing the entire trail or a portion of it?Then I turned my attention to the interior, and added a couple things for my navigator before we leave on the Trans American Trail next week.
I'm from Western PA, so we're starting at the beginning of the trail in WV, and planning to to go as far as the Smokey mountains in TN.I plan on doing the TAT next summer, where are you picking it up from? Are you planning on doing the entire trail or a portion of it?
Good luck, be safe and have fun!I'm from Western PA, so we're starting at the beginning of the trail in WV, and planning to to go as far as the Smokey mountains in TN.
I'm looking at about 1000 miles or if we run out of time, whichever comes first.