What did you do TO your Gladiator today? [ADMIN WARNING: NO POLITICS]

[UncleChanBlake]

Not today, but Monday. Line-X’d the bed. They did a great job. I asked them if I needed to put screws in the thread holes. They said no, they would make them useable. They did. They step-drilled them out a bit. Worked great. My tie-down bolts went in without any problems.

Sponsored

 

[Dezerox]

Those wheels look great what is the offset on those?

+1

 

[CoWhiteGladiator]

I bought the quake led fender chop for my sport s and figured out away to keep my inner fender instead of tossing it away. I absolutely love the look of it and they are super bright as well!

 

[SF_E60]

Thats awesome with 37's! Did you change gearing?

That's amazing! Is that all freeway or streets as well? I'm on 37's and the best mpg I can get is 18mpg. That's w/half bed rack rooftop tent and gear. I haven't re-geared yet either.

 

[GEETCH]

Thats what I did with the ecm, got a second one and had it flashed with my vin and then sent it in to Magnuson to get there flash done.
I like the magnuson but I am getting some custom remote tuning done as I type this. The magnuson tune is good but I think there is more that can be done with it or maybe just refined. Especially at interstate cruising speeds. 60 mph and under it is great. Little thirsty at 75 and over plus I think the shifting needs adjusted to match the higher speed cruising and power, torque from the supercharger.

Just a quick question for you, where did you get your second ECM from? I have been looking for one.

 

[KurtP]

That's amazing! Is that all freeway or streets as well? I'm on 37's and the best mpg I can get is 18mpg. That's w/half bed rack rooftop tent and gear. I haven't re-geared yet either.

the loop is a mix of interstate, highway, stop light to stop light, and back country hilly/windy road.

going to regear to 4.88 in a couple weeks. The difference right now is the pulsar and mopar intake.

 

[Lucky1]

I bought the quake led fender chop for my sport s and figured out away to keep my inner fender instead of tossing it away. I absolutely love the look of it and they are super bright as well!

Do you happen to have/could you take some pics of how you accomplished keeping the liners? They look great, and am thinking about upgrading to those!

 

[mazeppa]

Received my custom-made Jeep center cap decals. They look terrific!

I got the idea on this forum. Thank you!

@aldo98229 where did you purchase the decals from?

 

[aldo98229]

@aldo98229 where did you purchase the decals from?

Sent you a PM.

 

[JTPatriot]

Just a quick question for you, where did you get your second ECM from? I have been looking for one.

Purchased the ECM from the dealer, then had them flash it with my oem tune before sending it to Magnuson. Got it back before the install so no waiting for it during the install.

 

[Gren71]

Expounded on an idea from another forum member.

I made magnetic 12v light pods that I intend to use for extra light while backing up my travel trailer in low light.

 

[brain]

Expounded on an idea from another forum member.

I made magnetic 12v light pods that I intend to use for extra light while backing up my travel trailer in low light.

Clever.

 

[Gatorized]

Expounded on an idea from another forum member.

I made magnetic 12v light pods that I intend to use for extra light while backing up my travel trailer in low light.

Nice ! Do you have a parts list and links?
Should have piggy backed on the trailer electrical outlet on the bumper. Does the 7 pin have reverse lights?

 

[Gren71]

More of a for my jeep than a to my jeep

took down the old hand crank for my hard top lift and Installed an electric hoist

 

[Gren71]

Should have piggy backed on the trailer electrical outlet on the bumper.

im no where near that smart or confident in my wiring skills.

im still putting off hardwiring a dash cam to my aux switches because im not confident id do it right.

Sponsored