What did you do TO your Gladiator today? [ADMIN WARNING: NO POLITICS]

[Code 3]

Black Crome/Solid Steel

What's not to like. The best hundred bucks I have spent so far on the Gladiator. Solid Steel/Black Crome/US Quality! Kit came with lugs. lock lugs and key and I am so happy to get rid of the factory crome lugs.

Link please?

Sponsored

 

[red/green hawk]

Trigger 4+ wireless switch. Quadratec 4" LEDs.

 

[Bullycon]

Installed the Amfib Snorkel

 

[4xjeepr]

New plate for front of my JT !!

 

[RCKLNDR]

DIY Bed Rail and L Brackets for phase 2

 

[Sportsbiz]

This was last Thursday before my Death Valley trip, but installed a WaterPort Day Tank to my Leitner rack. It required the drop down plate to clear my Rotopax, but well worth it as its placement is perfect near my "kitchen" set up at camp.

 

[Davekayc]

Those look like they were made for it! Do you think they will fit under a tonneau cover?

Easily . The yeti is about an inch taller than the pelicans . Its handy to have stuff stay dry. Because the tonneau doesnt seal no matter which one you have.

 

[mdyucca]

Link please?

Here you go. https://www.justforjeeps.com/gorilla-factory-black-wk2-lugs-with-locks.html

 

[mdyucca]

DIY Bed Rail and L Brackets for phase 2

Looks good. You must be getting ready for a rack. I did the same thing last week, using unistrut. I need to finish mine by adding anchor points. I think I have figured what I am going to use, Erickson 59170 flip anchor ring. I know the 5000lb is overkill but I believe it will look good and the rings will be able to be positioned along the unistrut. Happy Jeepin!

 

[4xjeepr]

Swapped out the silver/black trail rated badge for my newly arrived grey/black badge. Originally was going with all black but, wanted to have a visible but subdued badge. This fits the ticket perfectly.
Swap was effortless. If anyone is planning on deleting the badge permanently, be advised there is an alignment hole behind the badge.

 

[Strider62]

New decal from Pixel Decals.

If you don’t know what it means...let’s just say it’s my favorite Charlton Heston quote.

 

[-miko-]

DIY Bed Rail and L Brackets for phase 2

Eagerly watching. I've been considering building a rack that worked with the trifold soft tonneou cover in place. Do you have a build thread on what you're doing?

 

[JTCHELLEW]

New NFAB side steps to replace the Rubicon rock rails to make it easier for my Dad and wife to climb up & in. Plus they look a lot better

 

[JTCHELLEW]

Youngest son committed to UD, will join one half of his older twin brothers there; other at VT. Twins both Eagle Scouts. Proud Dad of all three Jeep loving boys (they share a 98 Wrangler)

 

[j.o.y.ride]

Re-centered the rear axle a smidge. Ratchets worked great, just know there's some hoses and wires you need to be sure your straps are under.

Sponsored