What did you do TO your Gladiator today? [ADMIN WARNING: NO POLITICS]

[HVYMETL]

@Bestop Sunrider installed, got tired of taking freedom panels off every day after work.

I see dead people...

Sponsored

 

[chrismeece74]

I see dead people...

Lol yeah Wife decorated her Wrangler for Halloween

 

[injaneer]

Plugged the drill holes from the front License plate that I did not need.

Wonder if I should drill out bottom two, so they match.....

 

[Montana_Wildcat]

Swapped out the soft top for my new-to-me (used) hardtop before the Montana winter hits. Very happy with the fit!

 

[ThatStinging_Jeep]

Finished the suspension lift and steering system upgrade today. Took her to the Oceano Dunes for a shake down run.

what sliders are those ?/

 

[polarisTXguy]

Brought it home! So let the games begin, the list is long and expensive

 

[Rubiwoo]

what sliders are those ?/

They are custom one offs I had made. No one had the features I wanted.

 

[MyRight]

I gave it a wash and got all of the bug splatter off of the grill.

 

[OnlyOne]

Added the 3/4” coil spacers to the rear. Was sitting too high in the front with the RC 2.5 spacers. Now it looks level. So easy. Found the dreaded RR axle seal leak. Cleaned it with Brakeclean and took out a bunch of that fiber fill that the vent had in it. Will check it going forward prior to a visit to the dealer.
Before 3/4” spacer

After

 

[Jc2112]

Added Warn Winch (Factory Steel Bumper)
Added JCR Off road Overhead MOLLE panel and wired and installed GMRS Radio.

 

[MDPensFan]

Installed the Oak colored Hotheads Headliners (looks really good with the Saddle seats), JScan adjusted for the bigger tires, and hooked up the iDrive throttle controller.

 

[DailyMoparGuy]

Installed hood latch locks. They’re pretty nice!

 

[MissionMan]

Created a bed divider with honeycomb plastic sheets. Wouldn't be a jeep user if I didn't put in a little extra effort to make it different. Still needs some finishing and a rubber edge, but it's lightweight, under 2kg's/4lb's

 

[antwon412]

Create a bed divider with honeycomb plastic sheets. Wouldn't be a jeep user if I didn't put in a little extra effort to make it different. Still needs some finishing and a rubber edge, but it's lightweight, under 2kg's/4lb's

That is sweet! I’d buy one of those.
For the Gladiator I haven’t even ordered yet

 

[MissionMan]

That is sweet! I’d buy one of those.
For the Gladiator I haven’t even ordered yet

It was a bit of a learning process. I'd probably make changes if I did it again, but it was a lot more effort than I wanted because I don't have some of the tools required to make like easier like a circular saw.

Sponsored