How to Install Oracle Lighting Pre- Runner LED Grill Kit for Jeep JT?

[ORACLElights]

The Oracle Lighting Pre Runner style LED Grill Kit for the Jeep Gladiator / JT kit allows you to add 3x LED Marker Lights to the front Grill of your Jeep Wrangler JL without any cutting or drilling. These super-bright 3-Watt LEDs make your Wrangler stand out and can be connected to your parking lights, Daytime Running Lights, or to an Auxiliary Switch.

Other colors are available. (Only Amber and White can be used On-Road.)

Kit Includes following:

- (3) 3W LED Billet Bolt Lights.
- Wiring Connectors, Cables, and Hardware.
- Installation Instructions.

Installation Video!


Check out the PDF Install guide HERE.

Comment below with any photos /videos with your step by step installation or completed mod!

Sponsored

 

[WRSurf]

The Oracle Lighting Pre Runner style LED Grill Kit for the Jeep Gladiator / JT kit allows you to add 3x LED Marker Lights to the front Grill of your Jeep Wrangler JL without any cutting or drilling. These super-bright 3-Watt LEDs make your Wrangler stand out and can be connected to your parking lights, Daytime Running Lights, or to an Auxiliary Switch.

Other colors are available. (Only Amber and White can be used On-Road.)

Kit Includes following:

- (3) 3W LED Billet Bolt Lights.
- Wiring Connectors, Cables, and Hardware.
- Installation Instructions.

Installation Video!


Check out the PDF Install guide HERE.

Comment below with any photos /videos with your step by step installation or completed mod!

How do you install these to the daytime driving lights?

 

[ORACLElights]

How do you install these to the daytime driving lights?

DRL wire cannot be used as a power source - Tapping into Park Lights will give manual control over LED accessory during daytime driving - LED accessory will turn on automatically in night mode when switch is set to AUTO - For full automatic control over the LED accessory use fuse F52 in the engine compartment fuse panel. You can view the wiring guide below:

 

[JackoJawBreaker]

I previously had the prerunner’s installed with Halogen DRL/Signal. I’ve swapped that out for a Morimoto LED DRL/Turn Signal. What wire do I tap into with the red prerunner power wire?

Appreciate any ideas!

 

[ORACLElights]

I previously had the prerunner’s installed with Halogen DRL/Signal. I’ve swapped that out for a Morimoto LED DRL/Turn Signal. What wire do I tap into with the red prerunner power wire?

Appreciate any ideas!

The replacement DRL/Turn Signal does not replace the factory wiring so the info above still applies ?

Sponsored