Search results

Allow me to clear up the uncertainty around LED equipped JT's and our lamps! As of 06/2022 all tail lamps produced have all the electronics built in to communicate with the BCM to circumvent the notorious "Dummy Error" you get the truck no longer see's the OE lamps. We also have plug & play...

Just so everyone is aware, @sharpsicle & I have been communicating via PM. Got him sorted as promised.

Hey there, If you probe the brown wire with 12v, the lights should light up at half intensity for Park Lamp. If you probe the red wire with 12v, it should light up full intensity for Stop/Turn. Shoot me a PM with your findings and I will work with you to get this sorted.

2023 is Finally Here! Shop New Products! The New Year is basically here and is sure to be filled with many adventures! Make sure you are ready for adventure by outfitting your ride with all of the best LED upgrades. For this weekend only use code NEWYEAR23 to save $23 off any purchase of $200...

According to the Tazer JL manual - The setting you're looking for is "Tail"

Hey George, EU spec Jeeps have a separate amber signal in the rear as required by law. This means there is a separate wire for turn signal unlike the US/CA spec which uses the same wire for brake/signal - Because of this, turn signal will not work for EU spec Jeeps unless a programmer such...

PM me your email and order details and I will make sure Customer Support gets this handled for you promptly!

The same light will work on another gladiator with no issues, therefore not a defect.

Correct!

We've recently discovered an issue for some 22 MY Halogen Equipped Gladiators which causes the BCM to shut down the park lights when LED tails are connected. This is not a product defect and the issue can be resolved by doing the following: - Remove the resistors plugged into the Flush Mount...

PM'ing you

JSCAN works 100%. It's just not as straight forward as setting the rears to LED for the signal out error message. Here's the instruction from JSCAN Support on what to do: To add to this instruction - We found that if you don't go in and clear all DTC beforehand, the error may still occur. So...

Since you have a programmer, try removing the black resistors and setting the rear lights to LED.

Hey! Yes, this is normal for the first couple weeks of use as the moisture in the trapped air inside evaporates. This won't affect the performance of the lamps and will go away and not come back. That will be more so with these since there are heating elements generating more heat for that...

It will retain memory, yes.

Hey there - You don't need to wire these to a switch. The ambient cold weather will keep these from overheating and they will turn off when the temp gets to a point where they are not needed.

Actually, the RGBW pods each feature 22 premium 5050 RGBW LEDs as opposed to the RGB kit which uses 1 red, green, & blue LED in each pod. The colors are brighter, more vivd, and mix WAY better. These are only offered in 4pc currently. But, as you can see below, the LEDs are arranged in 3...

I noticed that and we have addressed it! Thanks for the feedback!

The most ideal spot functionally would be somewhere on the grill. But we understand some of you are going to want to hide that & won't want it visible. Ideally, you want these to be in a spot where there is the least amount of engine heat. The spot you chose is a great place!

That won't be possible without constructing a full replacement mirror assy. These are replacement front covers for the original mirrors only.