Search results

If anyone in NorCal has a damage side panel let me know. I want to convert one of my glass panels to steel. So if your glass is broken I want that one 👍

Bumper spacers are available and ready to ship. Send me a DM for payment and shipping info. Thank you, Steve

Hcalory TB2, worked great zero carbon monoxide readings! Short video of readings inside while it was 17 degrees outside

First time out camping in the snow

couldnt upload here so posted on YT to link and share Heater temps and carbon readings, outside was 17 degrees

Camped out in the snow , zero carbon monoxide readings. At first start up though it was reading 10 points. But definitely could smell it was still heating up. But enough about, enjoy the outdoors!

Roughly 40 minutes went by. You can feel the cap on the outside is warming up already. So with air flowing circulating if you will. Just by touch the opposite side of the vent is warmer when touching the steel cap. And yup we’ve got a 10 degree change already. Figure once all the interior warms...

Test run preheating without anything but whatever inside it. Added nutserts and knob screws for easier install. Used a partial weather seal I had. But I’ll run it for an hour and see where it sits temp wise. another thing to think about is. The rsi cap has a vent which since there’s not actual...

just slide it open or closed and my pass through is designed to sandwich the glass between with a rubber seal against the actual glass . once I get all the kinks out and test it I might order thicker abs plastic or aluminum and fine tune it.

Made a pass through just need a couple more things to finish sealing it from rain and snow

Bump I’ve got spacers ready to ship. Message me directly for payment and shipping info thank you Steve

Yes, I have them ready to ship 👍 I’ll send you PM

More plates cutting

Having aftermarket liners already made life simpler 🍻 another thing that I don’t know the reasoning…. They say to take the positive connection from aux battery and route it back up to the main . I did it but don’t know why I have to when others leave it connected to aux battery without a ground...

I’ve seen videos on removing battery neg cable from main battery. But if I’m correct the newer models have the thicker and thinner cable swapped locations? So the thinner on my 2021 with prod date of 12/20 has the thinner attached with the L bracket. And id rather not lose that bracket since I...

Yes, same. As first post. Qty of 6; 1/8” plates , netting you 3/8” per side. $50 shipped

Thank you for all the referrals to other members here. I have three sets of (6 plates) remaining from this batch I’ll try and cut more in the next couple weeks.

maybe I read it too fast lol. I just use the two sided tape it comes with but I also use 3m adhesive promoter which makes surfaces sticky prior to applying

The frontrunner rack came with mounts to the rsi channels

I don’t want to steer you wrong but just lay down some card stock paper as I did to make a template. Transfer it to cardboard, test your fitment and trim adjust as needed the. Transfer that to the board.