Search results

I agree, the timing on their part wasn't good. I had much more lead time. I hope the dealer makes your rig as good as new, and you don't have any more leaks.

I had to do the same when I had my glass replaced last year. I had to remove my bed rack and tonneau cover before the dealer, and the glass company they worked with, would replace the glass.

thanks for the suggestion. i ended up rewiring the backup lights to the trailer plug since I need the auxiliary switches for another application

I had the same problem. you shouldn't have to use the resistors since you're replacing the factory LEDs. clear the codes first, then disable turn signal lamp diagnostics and hopefully the hyperflash will turn off. this is what worked for me with JScan

i have the same issue. thanks for all the suggestions.

clayton 2.5 & 35s

this finally worked for me too. I have the factory LED package. Oracle recommended I contact JScan (via FB), and this is what the JScan developers recommended I try as well

Yeah, I used the exact same JScan setting. I wrote that in my message to @ORACLElights last night.

I'm in the same situation, JTR w/ factory LED. I can clear the bulb out warning w/ JScan, but warning comes back on when I use the turn signals. I also have the dash hyperflash. All the rear lights otherwise work fine. I sent a PM to Oracle last night and I haven't received a reply yet.

how’s the ride with the TS? i’m looking at that too, thanks

so i was to clear that led out warning by toggling the various rear led adaptations off and on again. however when i drive the truck and use the turn signals, the warning appears again. guess i have to try another permutations w JScan

thanks. i reactivated the rear light diagnostics. then deactivated rear LED turn signals with JScan. i still get the warning in both lights. now it’s getting kinda annoying

thanks. i tried this, ‘deactivated’ all of them. turn off the truck for 5+ mins. then activated all of them again. waited for 5+ mins. turn on the truck and warning light still on for both. what am i doing wrong?

hi did this work for you? i did the same thing. i have the LED package. not using the resistors. turned off diag info for rear turn sigs with JScan in adaptations. i still get the tail lights out warning in both lights

below is a copy of the post from Oracle in the other flushed taillight thread… JP_Oracle Peak Sponsor (Level 2) Today at 11:24 AM Add bookmark #778 Lots of back & forth here so I'm going to summarize from my earlier posts just for the sake of combining in hopes that it's a useful resource...

same here. i have the stock LED lights so i didn’t use the resistors (as per the video instructions) and now i also get the warning that both turn signals are out. guess i’ll have to try and put the resistors in or try my JScan. my lights also not sit totally flush despite pushing in while...

i ordered on 4/21 and i didn’t get the recent email from oracle

i don’t have these speakers. but check out the review with photos by a gladiator owner. it may help you. good luck https://www.crutchfield.com/S-AVI0m6blwWi/p_500SPV65JL/Alpine-SPV-65-JLT.html

I contacted Rancho tech support via their website and got the longer U-bolt shipped to me. I had to tell them that I knew about the longer u-bolt after reading about it on this forum.

sweet build! is that an off the shelf or custom fridge slide? i have the same fridge and i’m looking at slides that don’t elevate the fridge too much since i still want it to fit below my tonneau cover. thanks!