So I strangely enough received this too and was wondering why. I got the Merrell/Jeep boots but the strange thing about it was it was mailed to me at my parents address where I haven't lived in at in well over 5 years...
Hi Benny,
I need to replace both my headlight switch and the dash piece it mounts into, managed to drive my knee into the switch while getting in one day and broke a bunch of the clips on each piece. I'm seeing to two part numbers for each piece so I'm not sure which one I need. I've got a 22...
Fun little side effect of my batteries dying and getting replaced, the GPS started reading the wrong location, middle of the ocean wrong. Has the dealership look at it two weeks after changing the batteries while doing my oil change, verdict was they needed to completely change the radio. I...
Figured I might as well post what ended up happening. Dealership took a look at it and both batteries were deader than the dinosaurs. It took several hours of charging to get enough juice in them just so they could fully verify that they were dead.They replaced the batteries and everything is...
My previous work trip I didn't have any problems, but during my last vacation I added a bunch of electronics. They probably added a bit a parasitic draw with out me noticing.
If it was holding 14.7 I wouldn't have had an issue but it was dropping down to almost 10 volts and the truck would...
AAA tried jumping it and it started but it definitely was not happy about the low voltage. I shut the truck off when I saw 14.7+ on the dash for battery voltage and just told them to tow it to the dealership. The voltage was all over the place with the alternator overcompensating for the low...
Yeah I'll set one up next time I go to work. I've got battery tenders on both my bikes, just figured the truck was getting driven often enough to not need one.
Didn't think this would be the next picture I posted on here...
I work overseas usually for three to four months at a time. Just got home yesterday and when my girlfriend picked me up at the airport she let me know my truck was completely dead. I usually have her drive it every few weeks to...
Crap, I just realized that you are talking about the 2.5s so idk if those parts will work 100% for those shocks. They should definitely work if you're using 3.0s, part numbers are taken straight off the parts kit manual.
Also for being an engineer I apparently suck at math, it 54 not 52...
It going to be a while before I attempt to do this but here's the parts. The bushing has an ID of 0.75in and the spacers have an OD of 1in. That tracks with having to press them in. The spacers have and ID of 0.56in which is 14.2mm. Hardware you can try to get the Fox parts or just get...
I've also looked around for that kit but same as you I've had no luck. Since the instruction sheet has the individual parts numbers I took a look at sourcing each individual part and it looks doable. Might take time though to piece the kit together.
Reminds me of having to pull apart one of the diesels generators on my ship last year. The guy I relieved refused to run it after he couldn't get it to start. The boss said that you just had to get the crank in the right position and it starts without issue. The teardown revealed the previous...
Was part of a two week trip from Reno to North Carolina, went for the Jeep Adventure Academy. On the way back stopped in Arches and Moab, managed to complete Fins And Things by myself but definitely would like a spotter then next go around. ?