Search results

I'm looking to buy some stock M/T Mojave Wheel and Tires like the one pictured below. Looking to purchase 1 or a full set of 4. Located in Ventura County CA and willing to drive a couple hours to pick them up.

I'm looking to buy a Steel Rubicon Rear Bumper with parking sensor holes. Scratched or chipped paint doesn't bother me. Located in Ventura County California

Hey Benny Could you see if there's any update on when these springs will be available? Front springs -68607513AB Rear springs - 68607529AA Thanks

You repeat the same steps and it'll re-enable the chime.

The picture looks like the seat slammers, not seat jackers. What size are they? Desert Does It link

You can disable the chime without using JSCAN or spending any money. 1. With ignition off, latch the seat belt 2. Turn the ignition to run 3. Unlatch and re-latch the seat belt 4 times. Leave seat belt latch on the last time 4. Turn the ignition off

Sego Canyon Road in Utah.

East end of the Mojave Trail.

Sunrise at Twin Points at Grand Canyon Parashant National Monument.

Looks good. What did you use for the backing? I also never noticed until your post that the cowl has seven slots like the grill.

I like the Gazelle T3. It's pretty easy to setup however, if there's going to be any wind you have to stake out the sides or the wind will push them back in. I didn't like the stakes it came with so I picked up some 12" solid steel round steaks which you need in this rocky terrain. It feels very...

Sunrise this morning.

I made it down to Twin Points at Grand Canyon Parashant National Monument. Over 150 solo miles off roading the last 3 days to get here. I'll be doing a full write up of the trip when I make it back.

So I was at the dealer getting my free Wave Oil Change and Tire Rotation and saw they had a 2024 4xe Rubicon X with the factory Warn winch installed on the steel bumper. I snapped some pictures for those who might be interested. Other than the ginormous "teets", I like it especially the winch...

No problem. If you need any other measurements let me know.

Gotcha The door itself is 56-3/4" but the opening in the canopy from inside of the seals is about 51-1/2". Hope the third picture helps to see the channel that surrounds the door opening. If you need anything else let me know.

I have a Contour Canopy with windows, but the doors should be the same size. What exact measurements are you looking for? Picture to draw on

I must have gotten lucky as I was able to get mine disconnected pretty easily. I used the index finger on one hand to depress the tab while also pushing up on the connector with my other hands index and middle finger at the same time, to make sure the tab was fully unlocked. Then I pulled down...

I think the weak link in my current design will be if the bottom of the rack can rock inward, it may stress the upper attachment. I'm doing a four week trip in March, including a week on the Mojave Road Trail and my bed will be pretty filled with totes and gear so I'm thinking that will help...

Glad to be of help. Forgot to mention that they also sell a version of this holder for Jerry Cans too. Jerry Can Holder