Search results

I've had some 35s on order for a couple months now. No ETA.

Ordered Apr 8. Shipped Tuesday. Out for delivery today.

If it makes you feel any better, the only time I actually see my sequential turn signals is when I turn them on and step out to check them out. Haha Looks like quake makes one none sequential fender chop kit, but it's not as slim and fancy. Good luck with your search.

interesting. A one bolt solution on the rear frame side vs 3 for rustys.

You could always try it yourself. Can of mopar match is $16 shipped. Use any clear coat. Even if you mess it up, you can always sand it and try again.

Don't think I've seen another post with 349. But no, gas 3.6

Nicely done. Painting mine now. Messed up the clear coat and had to sand it back down.

Mine shipped today. Should be here tomorrow unless it ends up in Alaska. Haha

Thanks for taking the time to share your findings. It's been very helpful.

Think it's on top driver side.

I also contacted them. They were quick to respond and said that they have forwarded the info to their engineers. Looking at the photo, it looks like I might be able to cut away some material and retain the heat shield.

I have the lid on a bucket set up and as a guy, I have to say it could be better. It get's the job done, but it's annoying having maneuver the front business.

I got this one to clear the flatlink 254mm Flip-Up Hawse Fairlead Mounted License Plate Holder + Mounting Screw Kit https://www.amazon.com/dp/B0791FR2FL

2021 jtr

Just looked and mine is the same.

They replaced my xd attenuator a few years after i bought it. Sent me the replacement so I could swap it out and send them the bad unit.

Depends. I've heard people get good deal. Local discount tires was like $30 a falken at 33 tire at less than 500 miles.. Haha

New connector and pins, same shit. So after wasting time with repinning the wires and a new connector, I went back to something I had tried before. Again, i inspected the wires and pins. I thought maybe they got pulled during linex. But they were fine as far as i could tell. So i tried noalox...

Wiggle your plug. If the light has gone south, I have one that works that I might be able to sell. I bought it to avoid going to the dealer as well. Hahaha. I paid $45.

Same problem here. I ordered a light off of ebay. And same results. So I ordered plugs off of aliexpress. Just arrived yesterday in the mail. I'm going to pull the pins and put them in the new housing. If that doesn't work, I'll repin the wires. I think there's an updated design to these...