Search results

Bump....price dropped to $53000

Price dropper to $53000, mileage is now 28898

See full build in my profile showcase linked below. All part included except the fridge and rooftop Roam box. I have original high line fenders as well that would be included with the truck. The RTT on the truck now has only been used 1 time. A little over 27,000 miles on it. I have...

How did you get the sheared bolt out? I just did the same thing installing the AWE Y Pipe. I spent about an hour trying to get it out with vice grips and WD40 but it did not work....my truck now sounds like a POS. Why Jeep would make one side with through bolts and one with weld on is beyond...

Looking for a premium soft top in the SC/NC area. Thanks!

Is this still available?

Nope, I used the stock bolts.

I just installed these. Awesome product! Shipped super fast and fixed my broken driverside bracket. Took 15-20 min to install both.

I have had a tick since the first second I picked up my JTR at the dealer in Aug of 2019. I mentioned it then and also brought it back numerous times to multiple dealers. It was dismissed as normal Jeep engine noise every time. I knew they were full of $hit. My JTR sounds like a 80's diesel...

Depends on where you live too. Down here in SC people still wave for the most part. Minus all the people from the NE invading our state.....Can always spot them with the front plate holders....

All the "wifi" hotspot in vehicles is is a SIM card that is permanently wired to your car/jeep/whatever. If you don' t have phone service you won't have a wifi hot spot either. the only thing that would work would be local connections i.e. other phones or tablets connected to the same wifi...

Sorry for the very late reply. Yes if you search YouTube for S & b intake on Jeep 3.6 you will see the video that shows on a dyno the loss of 19 horsepower.

I bought mine over the phone from a dealer in NJ. I flew up from SC and drove it 800 miles home on the freeway at a constant 85MPH the whole way. no issues at all.

Yes but you get my point though.....

Neither look good.

I also almost never hit 8th gear but I am almost never above 50 mph anyway. Someday I will do install 4.88 or 5.13 but I do such a small amount of wheeling and highway driving where I would need to make the change I cannot justify the cost. I am leaving this project to one of my last ones...

I have a Rubicon with 4:10 and 37's and it is an auto. I have no issues on or off-road. I am sure different gears would make it better but this truck is no race car anyway so....

Is there a small sauna in the passenger footwell? That would do it for sure.

Could probably 3D print an insert to fit the connector perfectly

I have three kids under 10 and have no issues around the safety of this truck. As mentioned by a few other people the safety options available are very good and work very well.