Search results

sorry I don’t! All I did was follow the 12v adapter instructions from Quadratec 12v adapter installation it was fairly straight forward

Synergy Mfg stage 3 lift, with their 4” springs up front and 3” springs in the rear

In December I traded in my built 2020 Max tow for this stingray Rubicon. I just installed a 3” lift and 35’s. This was my shakedown run. I’ll be upgrading to 37’s again very soon. Stock exhaust for now, I just have an Airaid intake

The 35’s are temporary. It’s an old set I had laying in the garage just collecting dust. I’m going 37’s very very soon. I can’t decide if I want the Mickey Thompson Baja boss MT’s again or or try the AT’s. Steering is getting upgraded before I go 37’s. Tie rod, drag link, steersmarts sector...

The Nitto Trail grapplers are one of the best off road tires on the market. It did everything I threw at it and was decent in deep snow too. I like to drive hard and fast through the desert and being that my JT is my daily driver they wore pretty quickly. The Baja Boss MT’s were the best mud...

I did it!! About a month ago I traded in my 2020 max tow for a certified used 2021 Rubicon with only 8000mi on the odometer. I got a great valued trade in for my 2020 Max tow, I actually came up about $15k so I put that down on the new ‘21 Rubicon. I parted out most of the max tow to put on the...

Question, are you running 3” front and rear?! I’m looking to replace my springs but I don’t want any rake. Not sure if I should go 4” front with 3” rears or 3” front with 2” rears

prpseats.com or Katskin.com - I went the custom PRP route:

Hi everyone I’m in the process of upgrading my current 3.5” lift, and I was wondering if anyone out there with a bone stock gladiator with the max tow package can help me out with some measurements. If anyone has these I would really appreciate it!! front driver: hub to fender/floor to fender...

I was in the market for them also. Local Discount Tire said they called Mickey Thompson and they are on a national back order of up to 6 months. So I ordered mt’s instead to replace my trail grapplers

i don't know i guess you could do that too

I just drilled a small hole for the wires to fit through. I suppose if you don’t want to use the screws you could get away with using 3M VHB tape.

here’s a link to the instructions.

This is the route i took: - 12V Dual USB Panel - 12V Power Adapter About $30 and 30 minutes to install. Easiest mod I ever did

Just 1 cut to remove the excess plastic around the stock lights. I kept the bottom lip and did a lot of trimming of the inner fender liner. I also used some of the plastic I trimmed off the fender to create a filler piece which I epoxied back on. Otherwise you would be left with a gap between...

Oh here’s a few videos too…

October ‘21 - outskirts of Las Vegas:

Reviving this old thread. I just got a set of Quake Led’s smoked fender chop kit on Black Friday. I installed them on my max tow and it turned out pretty good imo. I didn’t take apart the fenders and I kept the inner liner intact. What do you guys think? Before: After:

Depends on your budget and needs. Check out these companies Evo Mfg Enforcer Synergy Mfg Teraflex Rock Krawler

I second Milestar Pat's. I always here good things about them. I currently have 35'' nitto trail grapplers and love them, but i want to go bigger. I'm debating going to 38" milestars msyelf