A lot of wire to put behind the bull bar. I would like to cut the two pieces out and put them where I want but not being sure what they are I’m reluctant to do so.
Now if I only knew Chinese, I would email them. ?. Not complaining, I knew what I was getting into at the price point. I’m happy...
Purchased this camera based on your post and put it on the bull bar. Questions about the wiring. Did you attempt to relocate the antenna and /or the other “bump“ in the wiring. I’m assuming this is some kind of resistor that reduces the voltage from 12v to USB voltage. These two items add quite...
I’ve been rear ended twice. Both times the hitch skid plate slid over the top of their bumper driving the car under the truck with no damage to my vehicle. Their grills did not look so good.
The last part is key. I did not loosen those nuts and could not get mine to line up. Ultimately I got frustrated enough that I took it in and had it installed. If I had just loosened those frame mounts I would have saved myself some money.
Looking at the JScan device. Mainly want it to change the tire size when I get new tires in the next couple months. Will I need the SGW cable to make this change?
Take it in and have the dealer fix it. Last I looked the emission warranty is 8 years, 80,000 miles. Easier than trying to screw around with the dealer that sold it to you.
Two sets of KC lights installed. Spots on the A-Pillar with wider lights on the bull bar. Combined with the factory lights there is a ton of illumination in front of the truck
Did 14,000 miles cross country using the Wavian cans and mounts and Billie bars and their Molex panels. The only bummer was that you would think that after all these yours that the Wavian mounts would work with Molex stuff. But they did not and I had to build brackets to mount them to the Molex...