Search results

I suppose another option is 3.5” lift…problem solved. 😂

Obviously this is personal preference so I suspect you’ve already decided but I love my autolynx and personally don’t care to be a rolling advertisement if I can help it so I’d cut the liners and move on. That’s just me and I certainly wouldn’t judge you if you disagreed. You could swap them for...

You can’t talk about offset without wheel width. The two go together otherwise it’s not an apples to apples comparison. To answer the OP question, yes a spacer will solve your problem. Many people don’t like them for justifiable reasons but some people roll with them for years problem free. It...

It’s been a few months but I found the Teraflex 1.5” spacer for less than $30 on amazon. That’s what I’m using with my Clayton 3.5” lift.

There’s a teraflex 1.5” spacer on amazon for somewhere around $25. That’s the one I used with my Clayton 3.5”.

Much like you I drove mine stock for a year or so before any major changes however the first mods I did in that year of driving it stock were dead pedal, stubby antenna and grab handles for the fam. After the year was over I did wheels, tires, lift, Autolynx, derringer and pedal monster.

Odds are you’re fine but to be 100% sure reach out to Clayton and ask. I just put one of their lifts on this month and they were very responsive when I had questions.

Yes, quite a few on here use it including myself.

So I did the best I could with the tools I have. I feel pretty good about most of them but I had a tough time with the passenger side front upper control arm jam nut. I could get my wrench on it but the exhaust prevented me from being able to really crank down on it. There’s just not enough...

Just finished up the Clayton 3.5” diesel Overland+ lift, Autolynx, Bilstein 5100’s and falcon adjustable stabilizer

Thanks for everyone’s input. That’s what I was hoping to hear. I’ll just use my 24” crescent wrench to tighten as much as I can and leave it at that.

I sent @Clayton Off Road an email via their website with this question but they haven't responded yet (might not be open today). I'm installing an Overland+ 3.5" lift on my '21 JTOD and the torque spec for the Clayton jam nuts on the instructions seems astronomically high, 398 ft-lbs and 723...

Thanks, I'll be back at it in the morning!

In the process of installing a Clayton Overland+ 3.5" lift on my 2021 JTOD. I'm getting ready to drop the rear axle and trying to figure out what this hose is and if it's ok to disconnect it? It attaches to the axle and then runs up to a plastic clip where it attaches to the underside of the...

If the only reason you’re considering the Mojave is the 4.10 gears then stick with your lower mileage High Altitude. Once you put your 35s on you can decide for yourself if a regear is necessary.

I’m going to grab some popcorn and watch y’all get roasted for that angry grill. :LOL: For real though, nice doors!

You're missing a key piece of info. Offset without knowing the wheel width is misleading at best. According to the Apex website you need at least 4.75" backspacing but they prefer 4.5" with the narrow axles. In order to achieve 4.5" backspacing on an 8.5" wide wheel that is -6 offset but its -12...

Thank you!

Thanks, that is very helpful. One question though, how thick is the Spicer? I didn’t see dimensions in the description.