Search results

Yeah my alignment shop noted that my tie rod had a bit of play in it, steering is definitely on the to-do list. I also just did ball joints about a week ago. I put on the 37s and noticed a little slop, I went with the American Iron Off-road ball joints deletes, they’re solid as a rock now.

It’s a 2022, just about to roll over 50k miles. I’m thinking LCAs will indeed be the starting point.

This is very helpful thank you. I was planning on rocking the stock driveline until failure. And like you mentioned I don’t really trust RC either, pretty skeptical on it, I was looking into the Adam’s or tom woods shafts also, or having one built locally, I think there’s a few places. The price...

Hey all, I know this topic is discussed extensively, but I’ve searched this forum quite a bit and come up short on a few questions I need answered. Most of it in regards to geometry correction with my “Franken-lift”. A quick rundown on parts… for starters I have 2” synergy lift coils, in which I...

So to anyone still following here, I’m getting started on the project (with my shop helper of course 😂). I picked up a VIAIR compressor off marketplace for $50, extended the 12v cord, wrapped it in conduit and found a good place to mount it. I ordered a stainless steel line to get the air from...

Just saw another forum on that, nobody seems to know what it’s for! Seems like it could definitely be done. I wonder if jeep is adding those and they will come out with a parts kit to add a compressor later.

I assume he had custom fabricated brackets to mount the compressor? I was looking around the spare tire and there is tons of room for activities down there, even with a 35” spare. There’s not a ton of room inside the actual bedside like I was thinking, but down lower near the frame would be a...

This is genius! I might like this idea better than the bedside. My only issue is I have the go-rhino hi lift mount on the driver fender, and had to modify (beat with a hammer) my stock Rubi rock rails to fit the mount lol. Rubi rock rails are easy enough to come by though and I was considering a...

First post here so I’m hoping I can get some good info/ideas! After extensive research I’ve come up a bit short on finding what I’m looking for. I’m a PPF installer and recently was inspired by the integrated on-board air on the new Tacoma trail hunter I recently worked on. It’s a compressor...