Texas Gladiator Rubicon Launch Edition 39in KM3s/RCVs/MetalCloak

[davetha]

My Gladiator Rubion Launch Edition build has been a great journey, especially since when I bought it there was very little aftermarket suspension and slider options etc.. It even made the
front FB page of Metalcloak.

I’m at a point in the road where I think I want to go back to using a tow rig and trailer a Jeep, vs having a very well built daily driver and weekend warrior.

I currently have around 5700 miles on it, and all of that 5700 miles has been very enjoyable!


Its current setup is below.

• 5x 39x13.5R17 BFG KM3s
• 17inch Method Wheels w/ Gorilla lugs
• 3.5inch MetalCloak Game Changer lift
• JE Reel 1350 front drive shaft
• 5.13 Gears Front & Rear
• One piece RCV Axle shafts w/ FAD Delete
• Front Artec Truss
• Front Artec C gussets
• Ace engineering rock sliders
• Synergy Steering Sector Shaft Brace
• Fox 2.0 shocks
• Fox Steering Stabilizer
• Bestop run rider + hard top panels
• AEV Front and Rear Differential Covers
• Skidmark 4x4 receiver hitch skid plate
• ZAutomotive Tazer

I have taken it out a couple of times. There is some minor rock rash on 2 of the wheels, a scrape on the front and rear bumper corners and the rock rails have some light contact under them.

$65,000 OBO. Willing to do a trade for a JK-U (2012) or JL-U + cash as well.

Located in Cypress, TX

Sponsored

 

[NoodleKranker]

How much cash on top of a JLU Sahara Trade?