Powered Sub- wiring help

[GOSKN5]

I have never wired an amp from a factory system before and it’s been a while since I have done any car audio stuff.

I ordered the Infinity BassLink mini to add a little bass to the Gladiator.

I need to know how I can access the wires listed in the instructions as shown? In the roll bar there are two speakers on each side, each with a gray and white wire. Can I tap into the roll bar speakers? Do I need wires from each side, or one side both speakers or what? How do I know the polarity?

Thanks

for the help!

Sponsored

 

[sirsamuel764]

Man, no response on this? I see you figured it out in the "what did you do" thread. I'd love to see a write-up on this. I am very interested in getting this same sub for my gladiator so I might have to pick your brain when I get it.

 

[GOSKN5]

Man, no response on this? I see you figured it out in the "what did you do" thread. I'd love to see a write-up on this. I am very interested in getting this same sub for my gladiator so I might have to pick your brain when I get it.

Yea, I got some help on Facebook.. was pretty easy really. The sub is amazing, I’m very impressed with the variety and depth it adds.

Basically, pull the signal from the wire harness in the passenger side pillar. Tap into it and run the wires, not too hard overall.

 

[wiredup60]

Yea, I got some help on Facebook.. was pretty easy really. The sub is amazing, I’m very impressed with the variety and depth it adds.

Basically, pull the signal from the wire harness in the passenger side pillar. Tap into it and run the wires, not too hard overall.

Cool install, do you have a quick right up on exactly how you did it? thx

Sponsored