Quake fender chop not working properly...?????

[LCF]

I just installed a set and now my driver side blinker comes on when i turn parking lights or headlight on ???? They work correctly in any other on mode..???? My driver side rear blinker does not flash when front is flashing. No codes on dash or tool....?????? Any ideas ?????

Sponsored

 

[LCF]

got a call back from their tech guy and resolved my issue

 

[Jezz]

Did you call Quake LED for tech support?

 

[Red Hot Sloth]

Curious, how was your issue resolved?
Same thing happens with mine except on passenger side.
I just installed the 2 days ago but hadnt tested them while running headlights until this evening.
I sent a message through their “Contact Us” page but its friday after 7pm

 

[LCF]

Curious, how was your issue resolved?
Same thing happens with mine except on passenger side.
I just installed the 2 days ago but hadnt tested them while running headlights until this evening.
I sent a message through their “Contact Us” page but its friday after 7pm

I cut the green wire on driver side....on the quake harness side....i can double check when i get home in the am......working nights blows!!!!!

 

[Red Hot Sloth]

Good to know it should be fairly simple, I hope.
Much appreciated

 

[LCF]

Good to know it should be fairly simple, I hope.
Much appreciated

FWIW....not sure if he would have done it....but I was hesitant so he assured me that if i cut the wire and it did not work, he would call and have them send me a new set....maybe wait for a response to cover your ass....

 

[Red Hot Sloth]

FWIW....not sure if he would have done it....but I was hesitant so he assured me that if i cut the wire and it did not work, he would call and have them send me a new set....maybe wait for a response to cover your ass....

I just wanted to give an update. It took a weeks worth if calling to finally get help with this. The weeklong wait was due to being in the field at various events. Once their tech was back in the office, the solution was dead simple.
Just like they told you, cut the green wire. Did the trick. They stated its a signal wire and wouldnt effect the operation of my DRL’s/Turn signal negatively. They were right, works like its supposed to.

 

[LCF]

I just wanted to give an update. It took a weeks worth if calling to finally get help with this. The weeklong wait was due to being in the field at various events. Once their tech was back in the office, the solution was dead simple.
Just like they told you, cut the green wire. Did the trick. They stated its a signal wire and wouldnt effect the operation of my DRL’s/Turn signal negatively. They were right, works like its supposed to.

good to hear

 

[tbaker]

Did y’all have LED turn signals all ready from the factory or what I thought the quake chop kit lights were plug an play now y’all are saying cut a wire the guy at quake told me you just plug them in to the factory location and that’s it I am about to buy the quake chop kit lights and I don’t want any problems

 

[Red Hot Sloth]

I had the stock halogen turn signal/drl before getting the quake fender chop kit.
I believe for most its plug-n-play, for myself and a few others its plug-n-play-n-cut the green wire

Sponsored