Sponsored
TxGladiator
Well-Known Member
- First Name
- T
- Joined
- May 13, 2019
- Threads
- 16
- Messages
- 191
- Reaction score
- 171
- Location
- Fort Worth,TX
- Vehicle(s)
- Gladiator Sport S
Did you have any issues getting the screw to seat all the way in the diode side marker?
I could only get mine in half way or so.
Was afraid of stripping out the screw so just ended up returning my set.
I could only get mine in half way or so.
Was afraid of stripping out the screw so just ended up returning my set.
OP
OP
JOKER8R
Well-Known Member
- Thread starter
- #3
No but I could see having an issue if you don’t hold it in place while tightening. Try loosening it and holding the marker exactly where it goes the tighten. Once it’s tight it should be a dead stop on the screw, I was afraid of cracking the bracket myself
JDLouisville
Member
- Joined
- Sep 30, 2020
- Threads
- 3
- Messages
- 19
- Reaction score
- 56
- Location
- Louisville KY
- Vehicle(s)
- 2020 Jeep Gladiator Rubicon
You have to get pretty aggressive with it. It was the same on my JL.
It’ll be fine.
Before and after pics
