How on earth did you mount your Rotopax plates to your Xtrusion Overland bedrack?

[corey21rubicon]

None of the holes line up, none of the Rotopax hardware will work in unison with the Xtrusion overland cross bars.. I feel like I am missing something here.

Are there other universal mounting plates one needs to get? Am I just a moron and missing something obvious?

Note below where it seems like the holes are lining up with the tracks on the xtrusion tread molle plate - the rotopax hardware hits the xtrusion cross bars so that will not work.

The spacing and sizing of the molle plate baffles me.

Sponsored

 

[gresults]

Did you check the spacing on the plate bolts, I think some racks use the mount without the plate if that makes sense.

 

[corey21rubicon]

Did you check the spacing on the plate bolts, I think some racks use the mount without the plate if that makes sense.

Good point I will check.

I did finally get the 2rotopax fuel tanks mounted but I have the rotopax traction boards and that will require specific spacing for the actual mounts obviously. Might just end up selling the traction boards if I cannot get this figured out

Sponsored