Search results

Get a banks Idash in a gauge pod, pull over turn off truck, clear code then on your way, less than 2 min lost

Used the pads for years now, work great

Redarc , thousands of miles on it dragging around my travel trailer

They were great until the insides of mine spilt , all four good luck

I use a snow methanol kit to keep the swirl gremlin away, 1.5 gallons of washer fluid per tank

This is my 25 gallon fuel cell setup, just an aluminum fuel cell with a sump, gravity feeds into the filler neck. Uses a rollover prevention valve to an open breather , works great and was around $400 bucks. Takes me about 5 minutes to remove and install.

Once again we need diesel only permissions to post in the diesel area

Balance beads here and will not go back, and I have heavyass bead locks

https://midwaytanks.com/products/auxiliary-gravity-feed-diesel-installation-kit-ford-gm-dodge

Too much HDR in photos

$85 and does an amazing job of bleeding the cooling system https://www.harborfreight.com/cooling-system-test-and-refill-kit-64985.html

57 k update, rebuilt the control arms and trac bars, huge improvement. Grease in them has collected sand and dirt and turned into a solid.

EOC stage 2 and Amazon thermostat recommended by Wolfoverland 902-3040 Upgrade Aluminium Coolant Thermostat Housing Assembly Fit for Ram 1500 2014-2022 Fit for Jeep 2021-2022 Gladiator 2014-2021 Grand Cherokee 2020-2022 Wrangler 3.0L Replace 68253514AA https://a.co/d/07FBrHpq

Honestly I believe so far the lower thermostat has made the most difference. I my oil cooler is with the insane diesel bypass filter setup so the oil flow isnt very huge. I see more once the weather gets warmer. I believe the radiator will be a big help after seeing the size of the stock...

Gravity fed 25 gallon fuel cell that can be removed in a few minutes, under $400 installed

About 2 hours, warning I’m a former mechanic with a full box

csf has less fins per square inch. The factory has more tubes and tighter fins, but is just a tiny radiator period. Once you see it out of the truck you understand why it gets hot.

unknown on power gains, did it more for lower egts and cleaning out the intake track. I tow a travel trailer and it gets a bit warm. Though on my highest tune it really moves

Show me where you can buy enough for all 8 control arms with the balls for less.

Evo control arm rebuild day, 57k on them. The sell a bushing kit for $250. You’ll need a press and 90 degree snap ring pliers. I also have a bead blasting cabinet I used too clean the balls up.