Search results

i think you might be right and i have been wondering how the centerforce clutch will handle this transmission because i am thinking this might be one of those transmissions that have the issue of the wobble with the input shaft. based on all of the research that i have done and all of the the...

these two articles are a very good read and hey help explain the propose of the dual mass flywheel which follows what the tech manual states.

in doing my research, i went to the tech manual and found this: "The dual mass flywheel is used on all engines. The flywheel incorporates the ring gear around the outer circumference to mesh with the starter to permit engine cranking. The primary flywheel side is bolted to the crankshaft...

i finally have the jeep back up and running. the two issues that i had was not with the clutch system or putting the jeep back together, it was with the slave cylinder and setting up the shift cables. the slave cylinder would not bleed properly so i had to remove the slave cylinder and do the...

good evening all what a project. i started on Sunday and got to the point where i had to stop because i was getting frustrated with removing parts. i stopped at the transmission and planned on removing the transmission on Monday. the nice part was the parts from Allmoparparts.com were to be...

good afternoon all, as you know, i have to replace the clutch assembly in my jeep. i have sitting at home the flywheel assembly and the throw-out bearing. i just received the email for shipping of the clutch assembly. i had to go OEM because Centerforce has not released theirs yet. i will be...

Improved durability. in their dreams.

earlier today, i talked to Allmoparparts.com and found out the ship dates should be between the 15th and 17th of February for the clutch assembly. my plan is to tear down the jeep on the 20th and 21st because i will have received the shipping notice of the clutch assembly. i did order the...

yes there is. one outside the pressure plate and one inside the pressure plate.

I have an update on my search for a clutch. after contacting my local jeep dealer, the parts department explained there are 56 backordered clutch assemblies waiting to be filled across the country. there is an supply of 50 clutch assemblies being delivered on or about the 9th of February and...

south bend release is not until at least April as well. it is a good thing that i do not need the jeep this summer because i will be out on the motorcycle for the summer on the east coast.

that is a good point.

i have just been informed that my jeep is down until at least the middle of March if not a whole lot longer. i talked to Benny at Allmoparparts.com and he told me the parts are not available for at least 30 days. i contacted BAM automotive and they told me the pressure plate and clutch disk...

what was the break-in period?

i understand what you are saying. the only part of the jeep that i have not touched is the engine and transmission and with the clutch being between the two i am ok with that. it is funny, the clutch went out when i had just put on 653 miles since the gear change and i have been wanting to do...

the recalls were done at 7,000 miles and 12,000 miles. if i have Jeep do the fix, they would put in the OE and that is not what i want done.

i believe it is worn out. i have just under 26000 miles on the clutch and have been off-roading with the vehicle 4 times in just over 2 years. i am going to start the teardown in 2 weekends so that when the Centerforce clutch comes in, i can do the install and be back on the road.

well, i am now in need of a clutch. i pulled out of the driveway and turned the corner and shifted to third and the weirdest noise stated to happen, i push in the clutch and it went away. let the clutch back out and the noise came back. looked at rpm and it was over 4000 with truck slowing down...

would it be possible to have a picture of the mounting to the bed?

any update on how the centerforce clutch is doing?