Search results

Thanks! No lift, just wheels and tires. Pro Comp 7005 (4.5 backspacing), with 37x12.50R17 BFG KM2. Its an old used set I bought for super cheap.

Has anyone found a green sun shade they like?

I'm a little surprised they're pulling power with an SAE40 oil around 260F. My thought when I saw my 3.6 oil above 250F, "That's a bit hot for SAE20." But for SAE40? Wow. But then again, modern mil spec helicopter gear oils I'm familiar with are comparable to SAE20, if not even thinner. The...

Spent my lunch break playing in the Mojave’s natural habitat….sand.

Are you being serious?

These temps don’t seem terrible to me. A little hot, sure, but it’s a diesel with hotter combustion temps. For reference, here’s a pic from this weekend of my Mojave towing maybe 4,000lbs on a 6% grade. Just sitting full throttle at 5k RPM, with only 2400 miles on it. And this is with the...

I keep coming back for the laughs though...

Curious to know this too, since the doors are aluminum now. I read that the front JL is around 48lb...

Yeah, I was quoted 6/18 - 7/2 as well.

Still not at the dealer...

It also seems possible this is the eMPG rating of the Gladiator 4xe, considering the Wrangler 4xe eMPG rating is something like 49.

My money is on 35" tires with a 40.4° departure angle

Are these pins pretty easy to pull?

Like others have mentioned, the Mojave has softer springs. So if you place the RTT over the bed, that's a significant load. If you distribute it with it mounted to the roof, that would help. I had this same predicament. I know realistically I'll spend a lot of time on the street, so Mojave...

I was informed by Jeep Chat that the Gladiator plant has not been impacted by any shortages. My order was on a train in 3 weeks flat.

Has anyone tried a 1" all around?

5/20: Ordered 5/23: D1 status and VIN 5/27: Trim status 5/28: Inspection status and Build Sheet 6/7: Pending installation of additional equipment. 6/11: Released, awaiting rail car. My dealer said it will take about two weeks from this point....I guess we'll see!

I didn't get a build sheet until it finished the build and went to final inspection. After that it went to "installation of additional equipment". I think its here that they install the spray-in bedliner.

Good luck! Mine completed the build a week after I ordered, and then sat in inspection for a week, and now going on a week "installing additional equipment".

Does it count that the interior furniture basically IS plywood? LOL (Former GAC interior engineer)