Search results

No i dont but it looked normal to me . He said the downward movement may have caused it. He also said there is no way of telling 100 percent what caused this to happen and may just be a parts failure. The tech said after the warranty is off i may want to look into a one piece driveshaft.

Nope they are covering it under warranty. The mechanic recommended it and said the whole driveshaft should be linear . He said when it’s sitting still it’s fine but when in motion it might have to much up and down movement for the bearing . He also said this may be a preventative thing to...

So my Jeep is at the dealer getting the rear driveshaft replaced because of a bad carrier bearing . They said the pitch was too much and made premature failure. I have a factory mopar 2.5 inch lift . My question is don’t ya think Jeep would have covered this in there lift kit ? Also there’s 3/4...

I installed a tazer and problem solved

I don’t remember . I measured it , I did have to cut a bracket off that hung a little low for the garage door opener

I have a mopar2 inch lift and 37s and it fits in the garage with about 2 or3 inches to spare

Hopefully this helps ya out

37/13.50/20 Patagonia tires

Fuel fsj wheels 20s

Good to see some positive stuff on the forum . I actually stopped looking on here because of all the karens complaining all the time . A jeep is never gonna be a cadillac dont expect it to be .

Thanks here’s a few more

A love hate relationship is right on the money but I am keeping mine for the long haul. To much fun not to .

thanks i will check it out .

Thanks I hate to waste the money on something that doesn’t meet my expectations

Yes I was gonna try the floor areas first to see if I noticed a difference

Bump

I am looking to reduce the outside noise and need some suggestions on products to use and hopefully some feedback from members that already did this.

ebay

i have one in the bottom of the differential so theres no need for one in the cover